To The Charge light is off on page 22 | AT&T TL7601, TL7651, TL7650

Troubleshooting

•Follow the directions for dial pad registration on pages 6-7. Wait for several seconds until the screen message changes to DIAL PAD, confirming that registration was successful.

•Disconnect and re-install the remote dial pad battery, then perform the dial pad registration procedure again.

•Reset the headset base. Unplug the unit’s electrical power. Wait for 15 seconds and plug it back in. The remote dial pad needs to be registered again.

•Other electronic products can cause interference to your cordless phone. Try installing your phone as far away from these types of electronic devices as possible: television sets, VCRs, or other cordless telephones.

The battery	•	If the remote dial pad is in its charger and
does not hold		the CHARGE light does not come on, refer
a charge.		to The CHARGE light is off on page 22 in
		this Troubleshooting section.
	•	Ensure that the battery is correctly installed
		with the plug securely connected.
	•	Charge the battery in the remote dial pad
		for at least six hours. For optimum daily
		performance, return the remote dial pad to
		its charger when not in use.
	•	You may need a new battery. Please refer to

Troubleshooting

to The CHARGE light is off on page 22 in

this Troubleshooting section.