AT&T TL7000 user manual Ring detector installation, Install the ring detector

Page 16

Getting started

Ring detector installation

The ring detector senses the telephone ringing and sends a call alert tone to the headset earpiece.

Adhesive tape

Ring detector’s sensor

Ring detector plug

Install the ring detector

1. Insert the ring detector plug into the RING DETECT jack on the lifter.

RING DETECT jack

Speaker

2. Remove the paper from the adhesive tape on the ring detector sensor.

Adhesive tape

3.Stick the adhesive tape as close to the telephone speaker as possible.

11

Image 16
Contents User’s manual Congratulations Parts checklist Table of contents Troubleshooting Quick reference guide Handset lifter Alert ON/OFFSmall lifter pad Handset lifter installation Lifter installationPress down Installation of large lifter pad optional Installation of anti-slip pad optionalConnect the headset base Rear view of the headset base connectionsHandset lifter installation DSL filter Color label Light blue Headset base installation with lifter see Figure Adjust lifter audio Ring detector installation Install the ring detectorAdjust the sensitivity level Headset incoming alert toneStatus light Handset lifter operation Make a call with the corded handsetButton Handset lifter operation Troubleshooting Troubleshooting Cannot dial out in Lifter Mode Lifter Audio Adjust switch Maintenance Cleaning your handset lifterTaking care of your handset lifter Avoid waterImportant safety information Limited warranty Limited warranty Limited warranty Other limitations Index