AT&T TL7000 user manual Handset lifter operation, Make a call with the corded handset

Page 19

Handset lifter operation

Handset lifter operation

After successful installation of the handset lifter, press the MODE button on the headset base until the LIFTER MODE light turns on.

Make a call with the corded handset

As indicated in the figure, lifting the handset causes the lifter arm to raise and release the switch hook.

You will hear a dial tone through the handset. You can dial normally using the telephone dial pad.

Release switch hook

14

Image 19
Contents User’s manual Congratulations Parts checklist Table of contents Troubleshooting Alert ON/OFF Quick reference guide Handset lifterSmall lifter pad Lifter installation Handset lifter installationPress down Installation of anti-slip pad optional Installation of large lifter pad optionalRear view of the headset base connections Connect the headset baseHandset lifter installation DSL filter Color label Light blue Headset base installation with lifter see Figure Adjust lifter audio Install the ring detector Ring detector installationHeadset incoming alert tone Adjust the sensitivity levelStatus light Make a call with the corded handset Handset lifter operationButton Handset lifter operation Troubleshooting Troubleshooting Cannot dial out in Lifter Mode Lifter Audio Adjust switch Avoid water MaintenanceCleaning your handset lifter Taking care of your handset lifterImportant safety information Limited warranty Limited warranty Limited warranty Other limitations Index