Answering system operation
Day & time announcement
To check day & time
You can press CLOCK when the system is idle to hear the current day and time without changing it.
To set day & time
Before playing each message, the answering system announces the day and time the message was received.
Follow the steps below to set the year, time and day, so messages are dated correctly. Each time you press 
SKIP or 
REPEAT, the year, hour, minute or day increases or decreases by one. Press and hold 
SKIP or 
REPEAT to increase or decrease the minutes or year by increments of ten. When you hear the correct
setting, press CLOCK to move to the next setting.
1.Press CLOCK, the system will announce the current clock setting, then announces “To set the clock, press CLOCK.”
2.Press CLOCK, The system will announce the cur- rent year setting, then announces “To change the year, press SKIP or REPEAT, to change the hour, press CLOCK.”.
3.Press 
SKIP or 
REPEAT, until the system announces the correct year, then press CLOCK.
4.Press 
SKIP or 
REPEAT, until the system announces the correct hour, then press CLOCK.
5.Press 
SKIP or 
REPEAT, until the system announces the correct minute, then press CLOCK.
6.Press 
SKIP or 
REPEAT, until the system announces the correct day, then press CLOCK. The system announces the current clock setting.
NOTES:
1.If the clock was not set when the message was recorded, the system will announce "Time and day not set."
2.Caller ID provides the time and date. Set the year so that the day of the week can be calculated from the caller ID information. After you set the time once, it will thereafter be set automatically with incoming caller ID information. The time will be set automatically only if you subscribe to caller ID service provided by your local telephone company (page 28).
33