Getting started
Telephone base and charger installation
Telephone base installation
1.Plug the small end of the larger power adapter into the power jack at the bottom of the tel- ephone base.
5.Plug the large end of the larger power adapt- er into an power outlet not controlled by a wall switch.
Power adapter
2.Plug one end of the tele- phone line cord into the tel- ephone jack at the bottom of the telephone base.
3. Route cords through slots.
| 4. Plug the other end of |
| the telephone line cord |
Telephone | into a telephone jack. |
line cord |
|
DSL filter (not included)
Charger installation
1.Plug the small end of the smaller power adapter into the jack on the under- side of the charger, then
route the cord through the 
slot as shown.
2.Plug the large end of the smaller power adapter into an electrical outlet.
IMPORTANT INFORMATION
1.Use only the power adapter supplied with this product. To order a replacement power adapter,
visit our website at www.telephones.att.com or call 1 (800)
2.This power adapter is intended to be correctly oriented in a vertical or floor mount position.
3.If you receive high speed internet through your telephone line (commonly referred to as DSL), and you are experiencing interference during telephone conversations and/or your caller ID features are not functioning properly, install a DSL filter to the telephone line between the telephone base and the telephone wall jack. Contact your DSL provider for a DSL filter.