Changing feature options, Feature options

Answering system operation

Changing feature options

1.	SETUP
	Press until desired fea-
	ture is heard (see list
	at right).

You can change how the answering system operates. Press SETUP repeatedly to hear each feature. When you hear the feature you want to modify press SKIP or

REPEAT to change the setting. Press SETUP to confirm your selection and move to the next menu option or press PLAY/STOP to confirm your selection and exit the

menu.

Feature options	(Default settings underlined).
System announces:	Feature description:

SKIP or

REPEAT

Press until desired selection is heard.

3. SETUP

"Number of rings," current setting, then "To change the setting press SKIP

or REPEAT; to continue setup, press SETUP." Options: 2/4/6/toll saver

Choose number of rings before the system answers a call. When toll saver is active, the system answers after two rings if you have new mes- sages, and after four rings if you have no new messages. When retriev- ing messages from a long-distance call, you may disconnect your call after three rings so that long dis- tance charges will not be charged.

Press to set selec- tion and move to next menu option.

- OR -

“Base ringer,” current	Choose base ringer volume to high or
setting, then “To change	low level, or turn the base ringer off.
the setting press SKIP
or REPEAT; to continue
setup, press SETUP.”
Options: high/low/off

PLAY/STOP

Press to set selection and exit menu.

"Remote access code," current setting, then "To change the setting press SKIP or REPEAT; to con- tinue setup, press SETUP." Options: (select two-digit code) 19

Select a two-digit number (10-99) for remote access from another tel- ephone (page 40).

NOTE: Press and hold SKIP or

REPEAT to increase or decrease the remote access code number by incre- ments of 10.

"Message alert tone,"	When on, the telephone beeps every
current setting, then "To	10 seconds when there are new mes-
change the setting press	sages.
SKIP or REPEAT; to con-
tinue setup, press SETUP."
Options: on/off

NOTE:

The message alert tone will beep only if all the conditions below are met: Answering system is on.

Message alert tone setting is on.

There are new messages. Pressing any telephone base key (except HANDSET LOCATOR) will temporarily silence the message alert tone. If you press DELETE in idle mode, there will be a voice prompt to direct you to press DELETE again to delete all old messages, the message alert tone will be temporarily silenced. The message alert tone will be re-activated with the next incoming message.