NOTES:
1.If you pause for more than four seconds during remote access, you will hear a help menu listing all features and commands. If there is no command for another 20 seconds, the call will end automatically.
2.If the system has many old messages, press 3 twice in remote standby mode to delete them. This process could take up to 18 seconds and you will hear a beep every second to alert you the system is deleting the messages. If you hang up while the system is deleting all old messages, the system will stop the deletion and exit. In this case, only some of the old messages will be deleted.
3.If memory is full, after 10 rings the answering system will announce "Memory is full, enter the remote access code." Enter your remote access code to enter remote access code.
Answering system operation
Remote access
You can access your answering system remotely by dialing your home telephone number from any
To remotely access your answering system:
1.Dial your telephone number from any
2.When the system answers, enter the two digit remote access code (19 is the default code, see page 35 to change it).
•If you have new messages, the system will automatically announce the number of new messages and then begin to play them.
3.Enter the following remote commands.
Commands in remote standby mode:
1Press to hear all messages.
2Press to hear only new messages.
3Press to deletes the current message (during playback).
3 3 Press twice to delete all old messages
4Press to repeats the current message (during playback).
4 4 Press twice to hear the previous message.
5Press to stop any operation (including recording).
*5 Press to hear a list of remote commands.
6Press to skip to the next message (during playback)
*7 Press to record a new announcement.
0Press to turn the answering system on or off.
8Press to end remote access (the call will be terminated).
4.Hang up to end the call and save all undeleted messages.
If desired, cut out the remote access wallet card at the back of this user’s manual for quick reference.
40