Radio Reassembly — Detailed |
6.2PC Board Disassembly
1.Remove the audio jack seal.
2.Remove the 10 screws which hold the PC board to the diecast.
3.Next, remove the 2 nuts on the On/Off Volume and Channel knobs shafts with the Crab Eye Nut Opener.
4.The PC board can now be removed from the rear diecast.
5.The completely disassembly PC board is shown in “Figure
Tanapa Label |
Radio Chasis
POGO Pin Seal
Thermal Pad
PTT Insulation Tape
Antenna Bracket |
Stickers for
Tuning Holes
Shield
Thermal Paste
POGO Pin Housing
Audio Jack Seal
Audio Bracket
PCB
Microphone Boot
Figure 2-7 Completely Disassembled PC Board
7.0Radio Reassembly — Detailed
7.1PC Board Reassembly
1.Place the PC board on the rear diecast.
2.Tighten the screws and the nuts on the two knobs.
3.Replace the audio jack seal.