Nortel Networks NT8B45AAAB manual T7406 Cordless Telephone Installation Guide

Page 1

Return

to Menu

Part No. P0942257 04

T7406 Cordless Telephone

Installation Guide

Read all documentation before proceeding with installation of this unit.

Warning: First-time battery charge

Follow this procedure for the first-time charge of your handset battery packs and when you first set up your T7406 system. Failure to follow all of these steps can result in operational difficulties.

Ensure that the battery pack is fully charged before you attempt to use your T7406 handset for the first time.

Charge the battery pack in the rear port of the charger for a minimum of 30 minutes.

Install the battery pack in the handset.

Put the handset into the front port of the charger and charge the battery pack in the handset for a minimum of three hours.

Trickle charge a spare battery pack in the rear battery port of the charger for 12 hours.

Ensure you configure the handsets in an orderly fashion. If you are configuring a number of handsets, ensure the battery packs for all the handsets are charged before you start configuring the handsets to the base station.

Refer to Handset Configuration on page 27.

Image 1
Contents T7406 Cordless Telephone Installation Guide P0942257 Contents Low battery Safety Important Safety Instructions Installation Use Contents Operational Bandwidths Provisioning the T7406Operational Parameters Installation Site Parameters Telephone-to-Base Range RF LANs Radio Frequency Local Area NetworksEnvironmental Layout Considerations Combination Office/Warehouse Environments Unsuitable for the T7406 Battery Charge Controller Powering the T7406OFF SpecificationsImportant battery pack information Radio range and coverage considerations About your T7406 telephoneSecurity of Conversation Density and InterferenceSpare Parts T7406 Parts ListsHandset Overview Out of range... message appears Handset Signal DetectionDisplay Handset FeaturesBase Station Features Installing the Base StationAntenna Mounting Bracket T7406 Pre-installation ProgrammingBefore you start Mounting and Connecting the Base StationCharging the T7406 Battery Pack First-time Charging Low battery Handset PowerRecharge Important First-time Installation Information Handset ConfigurationBattery levels Identifying the Handsets to the System Assigning the Handset to the Base Station Configuring the First Handset to a Base Station Using the Handset Display ButtonsConfiguring the Handset ID Number Changing the Handset ID Password Assigning the Security Code Configure the next handset to the base station Setting Handset FeaturesRing Type Lock Handset Ringer VolumeLanguage Handset System Feature Notes36 / Setting Handset Features Button Mapping on the Handset Memory buttons Programming memory buttons Button Inquiry System Feature codesHandset Asleep Mode Feature Conditions Handset Asleep Save Battery ModeMake a call Make and Answer CallsAnswer calls Mute microphone Hold callsHelpful hints Customize a handsetBacklight On/Off Assigning the Security Cleaning battery contactsInstalling the T7406 Handset Accessories Installing the T7406 Handset Accessories Leather carrying cases Optional accessoriesHeadset Compatibility Headset installation Canadian Regulations Regulatory informationUS Regulations Federal Communications Commission FCC NoticeFor Class a Host equipment EMI/EMC FCC PartImportant Safety Instructions SafetyFor Class B Host equipment Use Installation54 / Regulatory information Regulatory information
Related manuals
Manual 2 pages 29.98 Kb