Nortel Networks NT8B45AAAB, T7406 manual Before you start, Mounting and Connecting the Base Station

Page 23

Installing the Base Station / 23

Before you start

•Ensure there is an AC power outlet within 1.5 meters (5 feet) of the base station location.

•Ensure that the telephone lines from your system have been installed to the base station location.

Mounting and Connecting the Base Station

Follow these steps to mount and connect each base station.

1.Use the mounting bracket as a template to position the base station and mark the screw positions.

2.Use screws to attach the mounting bracket to a wall or ceiling.

3.Set the base station dip switches, located on the back of the base station, to the required ISM frequency band.

1 2 3

Upper half

ISM Band

Lower half

ISM Band

•On the first base station you install, set the dip switches to operate in the upper half of the ISM band. From left to right, set to Down-Up-Down.

•On the second base station, set the dip switches to operate in the lower half of the ISM band. From left to right, set to Down-Down-Up.

4.Connect the telephone lines to the base station.

a. Plug one end of the line cord into a telephone jack on the base station.

b. Connect the other end into a telephone port on the system equipment.

Note:Connect a maximum of three

TCMs per base station to the system.

c.Plug the small end of the power adapter into the back of the base station.

d.Plug the other end into an AC outlet.

Note:A red light flashes continuously on the base station when powered.

T7406 Installation Guide

Image 23

Contents T7406 Cordless Telephone Installation Guide P0942257 Contents Low battery Safety Important Safety Instructions Installation Use Contents Operational Parameters Provisioning the T7406Operational Bandwidths Installation Site Parameters Telephone-to-Base Range RF LANs Radio Frequency Local Area NetworksEnvironmental Layout Considerations Combination Office/Warehouse Environments Unsuitable for the T7406 Battery Charge Controller Powering the T7406OFF SpecificationsImportant battery pack information Density and Interference About your T7406 telephoneRadio range and coverage considerations Security of ConversationSpare Parts T7406 Parts ListsHandset Overview Out of range... message appears Handset Signal DetectionDisplay Handset FeaturesAntenna Installing the Base StationBase Station Features Mounting Bracket T7406 Pre-installation ProgrammingBefore you start Mounting and Connecting the Base StationCharging the T7406 Battery Pack First-time Charging Recharge Handset PowerLow battery Battery levels Handset ConfigurationImportant First-time Installation Information Identifying the Handsets to the System Assigning the Handset to the Base Station Configuring the Handset ID Number Using the Handset Display ButtonsConfiguring the First Handset to a Base Station Changing the Handset ID Password Assigning the Security Code Ring Type Setting Handset FeaturesConfigure the next handset to the base station Lock Handset Ringer VolumeLanguage Handset System Feature Notes36 / Setting Handset Features Button Mapping on the Handset Memory buttons Programming memory buttons Button Inquiry System Feature codesHandset Asleep Mode Feature Conditions Handset Asleep Save Battery ModeAnswer calls Make and Answer CallsMake a call Mute microphone Hold callsBacklight On/Off Customize a handsetHelpful hints Assigning the Security Cleaning battery contactsInstalling the T7406 Handset Accessories Installing the T7406 Handset Accessories Headset Compatibility Optional accessoriesLeather carrying cases Headset installation Federal Communications Commission FCC Notice Regulatory informationCanadian Regulations US RegulationsFor Class a Host equipment EMI/EMC FCC PartFor Class B Host equipment SafetyImportant Safety Instructions Use Installation54 / Regulatory information Regulatory information

Related manuals

Manual 2 pages 29.98 Kb