GE 10/02 Network Installation Install the Software, Step Two Install the Software

Page 4

Installation: Install the Software

Step Two: Install the Software

1.Insert the CD

Insert the CD in your drive. Choose Start -> Run -> Browse... -> SETUPUSBCLIENT\Setup.exe (look for this file on the CD) -> click Open -> click OK. The installation should then begin.

2.Choose the Default Settings

Click on Next several times until the installation process starts. In order to assure reliable operation and ease of service, please DO NOT change the default information as it is presented.

Please note this!

4

Image 4

Contents Network Client Guide Table of Contents InstallationVerify Your PC Compatibility Step One Verify Your PC CompatibilityInstallation Install the Software Step Two Install the SoftwareFinish Installation Installation Configure Your Client Step Three Configure Your ClientOperation Initial Setups Call Options Call Options❹ ❸ Initial Setups Call Options Initial Setups Call Options Initial Setups Call Options Initial Setups Call Options Initial Setups Call Options Daily Operation Starting a Call Job Starting a Call JobDaily Operation Checking Call Status Checking Call StatusDaily Operation Checking Call Status Daily Operation Checking Call Status Call Status is in this column Standard Call Statuses Member ReplyReference Importing Data …do this Click here first, then… Reference Importing Data Now the name of your imported file shows up here ReferenceThe PhoneTree Call Status Screen ReferenceThe PhoneTree Call Status Screen Call Status HeadersReferenceThe PhoneTree Call Status Screen Common Questions Common QuestionsPhoneTree Website Page Contacting PCS By PhoneBy E-Mail By MailRegulatory Information This equipment uses USOCs jacks RJ11