Audiovox DT 941 CI manual ~~~, Located on the back of the Base Unit. Figure

~

;;:.::"0;;...

.;;,.~, 'i I:"

~"

";""N"',;;;;WAbtir:'M O U N](N G t ,,;:ii,~;"'".~;t. .~.:.:;

,::~~;~;;

located on the back of the Base Unit. (Figure 2)

.;;:,...,

Choose a spot near an electrical outlet and a telephone jack. Your phone requires a modular telephone jack and a standard electrical outlet (120v AC). The power cord is six feet long; make sure there is an electrical outlet within reach of the base. The outlet should not be controlled by a wall switch. If the switch is ever turned off, the phone ~ill not operate.

2.	Position	the	wall mounting
	bracket	on the	base.
	Line up the tabs on the wall
	mounting bracket with the holes
	on the bottom of the base {Figure
-@-	1). Snap the wall mounting bracket
	firmly in	place.

Mount the bas~ on the wall. Position the base so the mounting studs will fit into the holes on the bottom of the base. Position the power cord to extend down the wall the phone is to be mounted on. Slide the base down on the mounting studs until it locks into place.

4.Connect the telephone line cord. The telephone line cord has a snap-in plug at each end. Insert one of the plugs into the jack on the back of the base. Insert the other end of the plug into the wall jack.

5.Plug the AC adapter into an

electrical outlet and the DC connecter into the power jack

9 -<.

Figure 1

Figure 2

-

-

-

-

a

~

J.-

:0

$

~

+

		14
~	14	~4/98. 12:20PM
OT94102.p65

~

rf