Audiovox DT 941 CI manual Repeat

Page 39

		ERASE		Key
		.Press		the	~		key during
		playback of a message to delete
		that	message.
		When the answering device is
		)::~,			press		and	hold	the
		LERASE J key for more thar}. 2
		seconds to delete all old (previ-
		ously		heard) messages.
		REPEAT		Key	--404
		Press this key during message
		playback to return to the beginning
		of	the	message.
		PLAY/STOP			Key	./~
		.Press		this	key	to	begin	message
		playback.			When		pressed,		the
		voice prompt will tell you the
		number of new and old messages
		stored in memory. It there are any
	-(fj}-	new (unplayed) messages, the DT
	-(fj}-	941 CI will play them and STOP.
		941 CI will play them and STOP.
		You can then press C~~T.9fJ
		again to review old messages.
		Press this key to STOP message
		playback.
		Press this key to exit answering
		device		programming mode.
			(g
			900~
		=-		-<:;)
		=-		-C>
		c=-		:" <:;)
		=--

ERASE

<OIc:>

co

--

O.CD

CD

~7~

~~PLAY/STOP

REPEAT

SKJP/QUJCK Key ~ , :,-

.During message playback, press

this key to advance to the next

message.

.Hold this key down during message playback to increase playback speed.

VOLUME UP/DOWN Keys- '6; T

.These keys control the loudness of

the Base Unit speaker. At the lowest setting (1 ), you will not hear incoming messages. To screen calls as they come in, raise the volume level from the minimum setting (1 ). 7 is the loudest setting.

MENU,	SELECT,		TIME/SET,~~eys			c'
.These			"	--".	used	for
		keys		are
answering			device	setup.		See
"Setting Up Your DT 941 CI Digital							+
Answering			Device".

37

~,	OT94102.p65	37	6/24/98. 12:20 PM
			~

rF

Image 39

Contents COl\tl1\1UNICATIONS caRp ~,,1.~...?. ,, , -.,.,.., .~fl.,,!!t OT94102.p65 24/98 PM Special Features -ANSWERING Device Special Features PhonePacks, call Audiovox Base UnitTFI,EPHONE Line Cord Urations Combination of devices RJit ~~rtC ~~~~~~anu Risks Audiovox Communications ~41Low battery message is Displayed 111.1.1Ftt Disposal, consult your local solid Battery into household garbage. ForImportant 00 not dispose of this Information on recycling or proper~a~ ~rl~t1gc- 0,!,,~~,.~i~t~t Telephonefill in the 11\ Ln.~Located on the back of the Base Unit. Figure ~~~=1t-~ Phone on is displayed when the phone is in use~-~ Repeat KEY Charging Contacts ~~I~i.i OFFBase Unit Message Window LED Program Location Memory Dialing speed Dialing ~f.t~l~~~~~~t?~r~~tifRitJ ~ilili.~iFor dial tone. Then dial the number you want 24/98 PM Your Dr 941 CI is capable of detecting Jm,irii~. ,.-, ...~l...!~~DVANeED Press ~ Or ~ To exitDisplay is cleared, then dial Normally Quick Memory Dialing Dial mode and leave the numcer Ii~e~~~n~~~~~ ~~6~tti~~~.~~~~On the display 111H T I 11t.~ .. l ~I~ L E T EI Press @1f to exit Alert signal, the LCD will display Name and number Caller ID serviceNumber when available will be With a Call Waiting signal. If you arePrivate CIDIrll Your DT 941 CI can answer incoming calls in 2 different ways SET Announce Onlyh It you would like to return to Tactory-set outgoing message ~~,~~~~,~f~iSet PLAY/STOP Base Ringer is on or OFFRemote Operation of the DT 941CI Repeat Answering Device -SET Security Code OT94102p65 OT94102.p6S FtJ None Thekeys YOU GET NOISE, sTATlc.16~ aPhone Doesnt Work AT ALL Handset does NOT, RingCommon Cure for Electronic Equipment OT94102p6S 6174/98 PM Receive Frequency WeightPower Reouirements FrequencyAudiovox Communications Corp Issueo