Audiovox DT 941 CI manual Remote Operation of the DT 941CI

Page 38

I

-@-

ON/OFF Key

This key turns the answering device ON and OFF .

.As you press this key, the voice prompt wilt confirm your choice: "Answering Machine ON (or OFF)"

The ON/OFF indicator glows wl)~n the answering device is set to ON. It is recommended that you leave your DT 941CI answering device in the ON mode, unless you do not want it to answer incoming calls.

This key has no effect on the cordless phone portion of your DT 941CI.

If the answering device is OFF; it can be turned on remotely by calling in and allowing the line to ring approximately 10 times. See

REMOTE OPERATION OF THE DT 941CI.

~

MEMO Keyc!!

~

.This key is used to:

.Record your outgoing message. See SETTING UPYOUR DT941CI

DIGITAL ANSWERING DEVICE . Set Outgoing Message.

.Record a MEMO at the Base Unit.

To record a MEMO:

.Press	~.		The	voice prompt
will	say	"Now		Recording",
followed		by a	beep.
.Begin	speaking.		Your MEMO can
be up to 4 minutes.

.Press (PLAY/STOP) when fin- ished.

.A memo must be longer than 2

seconds.

+

36

DT94102.p65	J6	I	6124/98. 12"20 PM

-@-

rf

Image 38

Contents COl\tl1\1UNICATIONS caRp ~,,1.~...?. ,, , -.,.,.., .~fl.,,!!t OT94102.p65 24/98 PM Special Features Phone Special Features -ANSWERING DeviceTFI,EPHONE Line Cord Packs, call AudiovoxBase Unit Urations Combination of devices ~anu RJit~~rtC ~~~~~ Risks ~41 Audiovox CommunicationsFtt Low battery message is Displayed111.1.1 Information on recycling or proper Battery into household garbage. ForImportant 00 not dispose of this Disposal, consult your local solid~a~ ~rl~t1gc- 0,!,,~~,.~i~t~t Ln.~ Telephonefill in the 11\~~~ Located on the back of the Base Unit. FigurePhone on is displayed when the phone is in use =1t-~~-~ Repeat KEY Charging Contacts Base Unit Message Window LED ~~I~i.iOFF Program Location ~ilili.~i ~f.t~l~~~~~~t?~r~~tifRitJ Memory Dialing speed DialingFor dial tone. Then dial the number you want 24/98 PM Press ~ Or ~ To exit Jm,irii~. ,.-, ...~l...!~~DVANeED Your Dr 941 CI is capable of detectingDisplay is cleared, then dial Normally Quick Memory Dialing On the display Dial mode and leave the numcerIi~e~~~n~~~~~ ~~6~tti~~~.~~~~ 111H T I 11t.~ .. l ~I~ L E T EI Press @1f to exit With a Call Waiting signal. If you are Name and number Caller ID serviceNumber when available will be Alert signal, the LCD will displayCID PrivateIrll Your DT 941 CI can answer incoming calls in 2 different ways SET Announce Onlyh ~~,~~~~,~f~i It you would like to return to Tactory-set outgoing messageSet Base Ringer is on or OFF PLAY/STOPRemote Operation of the DT 941CI Repeat Answering Device -SET Security Code OT94102p65 OT94102.p6S FtJ Handset does NOT, Ring YOU GET NOISE, sTATlc.16~ aPhone Doesnt Work AT ALL None ThekeysCommon Cure for Electronic Equipment OT94102p6S 6174/98 PM Frequency WeightPower Reouirements Receive FrequencyIssueo Audiovox Communications Corp