BT BT Versatility manual Connecting the Battery, Led Indicators

Page 24

BT Versatility

Installation and Maintenance Manual

Connecting the Battery

Ensure the battery switch on the BBU unit is turned off.

•This switch does not turn off the mains supply. The mains is disconnected by unplugging the mains cord

•Insert the battery into the battery cavity in the CCU

•Connect the cables from the battery charger to the battery ensuring that the cables are connected correctly. Red cable to Red battery terminal, black cable to Black battery terminal

•Turn the battery charger switch on.

•Reconnect the mains.

Led Indicators

A status LED on the BBU is provided.

•GREEN indicates the unit is running from mains power and the battery is charging or fully charged.

•ORANGE indicates the unit is running off the Battery

•RED indicates that the battery is discharged

•Flashing RED indicates the battery is disconnected and the switch is running from the mains

23

Image 24

Contents BT Versatility Contents Introduction General overviewSafety Precautions during installation and system upgrades Electrostatic precaution ESPLightning and surge voltage protection BT Versatility Pro. PlusIncludes System, VM, 1M,2V8 Maintenance items Installation checklist Installing the Central Control Unit CCU LocationCCUMounting the CCU Wall mount bracketCCU Mounting bracket clearances CCU Mounting BracketCCU Bracket + Backplane Bracket 300mm min Modules located in the CCU Module locationInstalling the Backplane wall bracket System ExpansionMounting the CCU with two brackets Mounting the Backplane Mounting screw holeExpansion Modules Installing an Expansion module Push up to lockInstalling the Analogue Module in the CCU Analogue line moduleAnalogue Module Remove the cover Locate the Module First network moduleTo Locate the Analogue Module in the Ports Module Installing the Basic Rate Isdn Module in the CCU Basic Rate Isdn expansion moduleDigital Line Module Isdn First network module To Locate the Digital Line Module Isdn 2 in the Ports module Second Module. Can be external T or internal SSystem Isdn settings T0 interface terminationS0 interface termination Voicemail module Back up Voice Module voice messages and GreetingsPrimary Rate Interface Availability TBC Connecting the battery backup unit to the system Battery charger connector on the PSUConnecting the Battery Led IndicatorsFeaturephone V16 Featurephone connections underside of phoneV8 Featurephone connections underside of phone Attaching the Featurephone desk plinth V8 Position at 35 degreesFeature phone with console To connect the V16 Console to a Featurephone V16 onlyV16 expansion console Expansion consoleClip, Plinth and installation of the V16 expansion console Wall-mounting a Featurephone Line cord railsWall hook when the V8/V16 is wall mounted Door IntercomConnecting the extensions Cabling the unitCabling Break outs Speech Pin Data Connecting a MOH Music On Hold Module CCU connectionsDoor Intercom Doorstrike Connecting a PA public Address amplifier Connecting a PC or Printer to the Serial PortPorts Module MDF Connections MOH Module containsInternet Module MDF Connections Options Module MDF Connections Central BellExternal Extension Cable limitationsInstalling an additional Network Analogue or Isdn module Installing additional modulesExpanding an Existing system Maintenance procedures Hot Swapping faulty modulesReplacing a faulty Module MDF Replacing Faulty PCBs Replacing the 008 extension boardReplacing the CCU Control PCB Power supply unit spare fuse Replacing the Power Supply Unit Spare FuseReplacing the CCU MDF Power fail AnalogueLine position Power up and test Switch onCommissioning Programming Equipped exchange linesIncoming ringing Call Barring Installation Wizard Internet Module ProgrammingAdsl Isdn Recommendations for customer training Troubleshooting Technical specification 230 ± 10% V 50 HzLAN Full remote support from a BT Maintenance Centre Index Offices Worldwide