BT BT Versatility manual Wall-mounting a Featurephone, Line cord rails

Page 30

BT Versatility

Installation and Maintenance Manual

Wall-mounting a Featurephone

The phone plinth is inverted on the base to wall mount the phone.

Locate, drill and plug the 2 screw locations as shown below. The holes should be deep enough to accept a

2.5cm screw. Insert the two screws leaving sufficient space to clip the base over them. Locate the phone and base over the screws.

Line cord rails

150 mm

Featurephone in Wall Mount position

V16 and Console in Wall Mount position

29

Image 30

Contents BT Versatility Contents Introduction General overviewSafety Precautions during installation and system upgrades Electrostatic precaution ESPLightning and surge voltage protection BT Versatility Pro. PlusIncludes System, VM, 1M,2V8 Maintenance items Installation checklist Mounting the CCU Installing the Central Control UnitCCU LocationCCU Wall mount bracketCCU Mounting bracket clearances CCU Mounting BracketCCU Bracket + Backplane Bracket 300mm min Modules located in the CCU Module locationInstalling the Backplane wall bracket System ExpansionMounting the CCU with two brackets Mounting the Backplane Mounting screw holeExpansion Modules Installing an Expansion module Push up to lockAnalogue Module Installing the Analogue Module in the CCUAnalogue line module Remove the cover Locate the Module First network moduleTo Locate the Analogue Module in the Ports Module Installing the Basic Rate Isdn Module in the CCU Basic Rate Isdn expansion moduleDigital Line Module Isdn First network module To Locate the Digital Line Module Isdn 2 in the Ports module Second Module. Can be external T or internal SSystem Isdn settings T0 interface terminationS0 interface termination Voicemail module Back up Voice Module voice messages and GreetingsPrimary Rate Interface Availability TBC Connecting the battery backup unit to the system Battery charger connector on the PSUConnecting the Battery Led IndicatorsFeaturephone V16 Featurephone connections underside of phoneV8 Featurephone connections underside of phone Attaching the Featurephone desk plinth V8 Position at 35 degreesV16 expansion console Feature phone with consoleTo connect the V16 Console to a Featurephone V16 only Expansion consoleClip, Plinth and installation of the V16 expansion console Wall-mounting a Featurephone Line cord railsWall hook when the V8/V16 is wall mounted Door IntercomConnecting the extensions Cabling the unitCabling Break outs Speech Pin Data Connecting a MOH Music On Hold Module CCU connectionsDoor Intercom Doorstrike Ports Module MDF Connections Connecting a PA public Address amplifierConnecting a PC or Printer to the Serial Port MOH Module containsInternet Module MDF Connections External Extension Options Module MDF ConnectionsCentral Bell Cable limitationsInstalling an additional Network Analogue or Isdn module Installing additional modulesExpanding an Existing system Maintenance procedures Hot Swapping faulty modulesReplacing a faulty Module MDF Replacing Faulty PCBs Replacing the 008 extension boardReplacing the CCU Control PCB Power supply unit spare fuse Replacing the Power Supply Unit Spare FuseReplacing the CCU MDF Power fail AnalogueLine position Power up and test Switch onCommissioning Programming Equipped exchange linesIncoming ringing Call Barring Installation Wizard Internet Module ProgrammingAdsl Isdn Recommendations for customer training Troubleshooting Technical specification 230 ± 10% V 50 HzLAN Full remote support from a BT Maintenance Centre Index Offices Worldwide