BT BT Versatility manual Expansion Modules

Page 14

BT Versatility

Installation and Maintenance Manual

Expansion Modules

There are three types of expansion module that can be installed on the back plane. These are the Ports Module, the Internet Module and the Options Module. All these modules are installed in the same way.

Modules are supplied in two parts. The MDF, which is connected to the backplane, and the module which is inserted into the MDF.

The Ports MDF is also equipped with two connectors for the Analogue and /or the ISDN Basic Rate modules.

The power must be disconnected when installing the Backplane or expansion modules

Module with MDF

Module and MDF separated

13

Image 14

Contents BT Versatility Contents Introduction General overviewLightning and surge voltage protection Safety Precautions during installation and system upgradesElectrostatic precaution ESP BT Versatility Pro. PlusIncludes System, VM, 1M,2V8 Maintenance items Installation checklist Mounting the CCU Installing the Central Control UnitCCU LocationCCU Wall mount bracketCCU Bracket + Backplane Bracket CCU Mounting bracket clearancesCCU Mounting Bracket 300mm min Modules located in the CCU Module locationMounting the CCU with two brackets Installing the Backplane wall bracketSystem Expansion Mounting the Backplane Mounting screw holeExpansion Modules Installing an Expansion module Push up to lockAnalogue Module Installing the Analogue Module in the CCUAnalogue line module Remove the cover Locate the Module First network moduleTo Locate the Analogue Module in the Ports Module Digital Line Module Isdn First network module Installing the Basic Rate Isdn Module in the CCUBasic Rate Isdn expansion module To Locate the Digital Line Module Isdn 2 in the Ports module Second Module. Can be external T or internal SS0 interface termination System Isdn settingsT0 interface termination Voicemail module Back up Voice Module voice messages and GreetingsPrimary Rate Interface Availability TBC Connecting the battery backup unit to the system Battery charger connector on the PSUConnecting the Battery Led IndicatorsFeaturephone V16 Featurephone connections underside of phoneV8 Featurephone connections underside of phone Attaching the Featurephone desk plinth V8 Position at 35 degreesV16 expansion console Feature phone with consoleTo connect the V16 Console to a Featurephone V16 only Expansion consoleClip, Plinth and installation of the V16 expansion console Wall-mounting a Featurephone Line cord railsWall hook when the V8/V16 is wall mounted Door IntercomCabling Break outs Connecting the extensionsCabling the unit Speech Pin Data Door Intercom Doorstrike Connecting a MOH Music On Hold ModuleCCU connections Ports Module MDF Connections Connecting a PA public Address amplifierConnecting a PC or Printer to the Serial Port MOH Module containsInternet Module MDF Connections External Extension Options Module MDF ConnectionsCentral Bell Cable limitationsExpanding an Existing system Installing an additional Network Analogue or Isdn moduleInstalling additional modules Maintenance procedures Hot Swapping faulty modulesReplacing a faulty Module MDF Replacing Faulty PCBs Replacing the 008 extension boardReplacing the CCU Control PCB Power supply unit spare fuse Replacing the Power Supply Unit Spare FuseReplacing the CCU MDF Line position Power failAnalogue Commissioning Power up and testSwitch on Incoming ringing ProgrammingEquipped exchange lines Call Barring Installation Wizard Internet Module ProgrammingAdsl Isdn Recommendations for customer training Troubleshooting Technical specification 230 ± 10% V 50 HzLAN Full remote support from a BT Maintenance Centre Index Offices Worldwide