BT BT Versatility manual Mounting the Backplane, Mounting screw hole

Page 13

BT Versatility

Installation and maintenance Manual

Mounting the Backplane

Slide the backplane on from the right hand side. Ensure the connector is fully mated with the CCU.

Securing the backplane to the wall bracket

A mounting screw is used to securely locate the backplane on the wall bracket. This provides additional rigidity to ensure the backplane and CCU connectors do not move.

Remove the fourth and fifth cover from the backplane.Locate the backplane on the bracket and connect it to the CCU. The backplane must be fully connected to the CCU to correctly locate the mounting screw hole. Insert the screw into the pillar on the bracket, which can be seen through the backplane mounting screw hole.

Mounting screw hole

12

Image 13

Contents BT Versatility Contents General overview IntroductionElectrostatic precaution ESP Safety Precautions during installation and system upgradesLightning and surge voltage protection BT Versatility Pro. PlusIncludes System, VM, 1M,2V8 Maintenance items Installation checklist CCU LocationCCU Installing the Central Control UnitMounting the CCU Wall mount bracketCCU Mounting Bracket CCU Mounting bracket clearancesCCU Bracket + Backplane Bracket 300mm min Module location Modules located in the CCUSystem Expansion Installing the Backplane wall bracketMounting the CCU with two brackets Mounting screw hole Mounting the BackplaneExpansion Modules Push up to lock Installing an Expansion moduleAnalogue line module Installing the Analogue Module in the CCUAnalogue Module Remove the cover Locate the Module First network moduleTo Locate the Analogue Module in the Ports Module Basic Rate Isdn expansion module Installing the Basic Rate Isdn Module in the CCUDigital Line Module Isdn First network module Second Module. Can be external T or internal S To Locate the Digital Line Module Isdn 2 in the Ports moduleT0 interface termination System Isdn settingsS0 interface termination Back up Voice Module voice messages and Greetings Voicemail modulePrimary Rate Interface Availability TBC Battery charger connector on the PSU Connecting the battery backup unit to the systemLed Indicators Connecting the BatteryV16 Featurephone connections underside of phone FeaturephoneV8 Featurephone connections underside of phone Position at 35 degrees Attaching the Featurephone desk plinth V8To connect the V16 Console to a Featurephone V16 only Feature phone with consoleV16 expansion console Expansion consoleClip, Plinth and installation of the V16 expansion console Line cord rails Wall-mounting a FeaturephoneDoor Intercom Wall hook when the V8/V16 is wall mountedCabling the unit Connecting the extensionsCabling Break outs Speech Pin Data CCU connections Connecting a MOH Music On Hold ModuleDoor Intercom Doorstrike Connecting a PC or Printer to the Serial Port Connecting a PA public Address amplifierPorts Module MDF Connections MOH Module containsInternet Module MDF Connections Central Bell Options Module MDF ConnectionsExternal Extension Cable limitationsInstalling additional modules Installing an additional Network Analogue or Isdn moduleExpanding an Existing system Hot Swapping faulty modules Maintenance proceduresReplacing a faulty Module MDF Replacing the 008 extension board Replacing Faulty PCBsReplacing the CCU Control PCB Power supply unit spare fuse Spare Fuse Replacing the Power Supply UnitReplacing the CCU MDF Analogue Power failLine position Switch on Power up and testCommissioning Equipped exchange lines ProgrammingIncoming ringing Call Barring Internet Module Programming Installation WizardAdsl Isdn Recommendations for customer training Troubleshooting 230 ± 10% V 50 Hz Technical specificationLAN Full remote support from a BT Maintenance Centre Index Offices Worldwide