AT&T 8410 manual Select Ringing Pattern, Self-Test

Select Ringing Pattern

You can select one of eight different ringing patterns for incoming calls. When there are several users in the same seating area, you can select a distinct ring- ing pattern so you can recognize when your voice terminal is ringing.

To select a ringing pattern, do the following:

1.While on-hook, press Shift , and then press Hold .

■The current ringing pattern rings repeatedly.

■The Shift lamp flashes.

■The display shows the current ringing pattern number:

SELECT RING PATTERN: 3

2.Press Hold repeatedly to step through the rest of the ringing patterns.

3.When you hear the ringing pattern you want to use, press Shift .

■You hear two beeps which indicates that the change was accepted.

Self-Test

To test the lamps on your voice terminal, do the following:

1.Press and hold Test .

■The lamps on the left side go on followed by the lamps on the right side.

2.Release Test to end the test.

■All the lamps go off, except for the Test lamp, which stays green for a few seconds.

32Issue 1 March 1996