Analog Telephone System

Setup with Analog Telephone System

If you are connecting the Voice Center Conference Phone to an analog telephone system, follow the instructions below. In North America, use the AT-103 Analog Telephone System Interface supplied with the conference phone; in Europe, use the AT-104 European Telephone System Interface (available in the EK-102 international adapter kit). Throughout the instructions, the Voice Center Conference Phone is referred to as "Conference Phone" and the Analog Telephone System Interface (whether AT-103 for North America or AT-104 for Europe) is referred to as “Analog Interface”.

1.Connect Conference Phone to Analog Interface using the RJ-45 conference phone cable supplied with the Conference Phone.

• Plug one end of the RJ-45 conference phone cable (larger than a standard RJ-11 cable) into the connector labeled “Control Box” on the underside of the Conference Phone.

• Place the Conference Phone on the table where it will be used. For best acoustics, place the Conference Phone at least 20 inches (0.5 m) from any wall and at least 6 inches (0.15 m) from the edge of the table.

•Plug the other end of the RJ-45 cable into the Analog Interface connector labeled “Conference Phone.”

PHONE	LINE	CONFERENCE	DC 15V
		PHONE

2.Connect Analog Interface to telephone jack using RJ-11 telephone cable.

•Plug one end of RJ-11 telephone cable supplied with the Conference Phone into the Analog Interface connector labeled “Line.”

•Plug the other end of that RJ-11 cable into a telephone jack.

PHONE	LINE	CONFERENCE	DC 15V
		PHONE

3.Connect Conference Phone power adapter to Analog Interface.

In North America, use 120 VAC power adapter (PA-102, supplied with Conference Phone); in Europe, use 230 VAC power adapter (PA-202, available in EK-102 European adapter kit).

•Plug DC plug on power adapter cord into the Analog Interface connector labeled “DC15V.”

PHONE	LINE	CONFERENCE	DC 15V
		PHONE

•Plug power adapter into a nearby electrical outlet (do not exceed voltage rating of power adapter).

Note: At this point, the Conference Phone will emit a musical jingle; this

self-test allows it to automatically calibrate its performance for the acoustic environment.