Crestron electronic DMTH4 quick start Initial Setup Hints

Page 15

Installation Guide

WIth the DMTH4 connection configured, it is now possible to set the Master/Slave operating mode. This is done by selecting “Device Setup” from the Control Panel Menu Bar. Select “Expansion Mode” from the drop down menu and select “Slave.”

Setting Master/Slave Mode

Initial Setup Hints

1)Right clicking the mouse is powerful in this inter- face. You can activate quick access to a number of setup functions (for example - right click in any input box in the INPUTS tab). It also allows some powerful cut and paste capabilities - especially in the matrix setup and the filter (both input and output).

2)Store startup settings in a startup default preset. (See Storing and Recalling Presets in the online HELP.)

3)Presets will take about 4 seconds to switch due to the many parameters in the unit - audio will switch off temporarily during a preset switch to avoid feedback. If you need quicker response with no interruption to the audio, use macros instead - try using the macro recorder for making any changes. The only changes that cannot be made in a macro are filter adjustments.

4)Store presets after changes are made and not before they are made.

5)Help is always available by clicking Help on the Main Menu Bar. This Help is a comprehensive resource and includes the latest revisions to the software and firmware.

IMPORTANT: Any changes made during setup must be saved in the unit via the preset menu.

For direct support from the factory, call (800) 821-1121

Ask for anyone in the SALES department. They will be able to answer your setup and/or technical questions or will get the correct person who can help on the phone.

Rio Rancho, NM

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents DMTH4 DMTH4 LECTROSONICS, INC Important Safety Instructions Table of Contents Unpacking the unit IntroductionControls and Features Front PanelRear Panel Audio Connections Hardware InstallationInstalling the DM system into a rack CablesProgrammable Outputs Audio Outputs AUX and CodecTelephone Line Jack Programmable InputsExpansion I/O ports Codec and TEL Remote Control PortsUSB driver installation Windows XP Installing LecNet2 Software and USB DriverInstalling LecNet2 Software Installing the LecNet2 USB DriverInstallation of Additional Units or LecNet 2 devices USB Driver Installation Windows Basic System Setup Initial SetupControl System Interconnections Using the DMTH4 Control Panel to Change Master/Slave Mode Master/Slave ConfigurationInitial Setup Hints DMTH4 Example Teleconferencing SetupSetting up the DMTH4 Main Matrix Setting up the DM1624 Main MatrixSetting up the DM1624 Expansion Matrix Setting up the DMTH4 Output Source Multiplexer Making a Phone Call Make a Telephone Call Using a Telephone SetMake a Telephone Call Using the Activity Tab Using the Touch Tone PadUse the Phone Book Use the Type the number to dial boxConnecting to the Codec Interface using the Activity Tab FCC Part 15 Compliance FCC Part 68 ComplianceInstallation Guide Rio Rancho, NM Limited ONE Year Warranty
Top Page Image Contents