Crestron electronic DMTH4 quick start Installation of Additional Units or LecNet 2 devices

Page 11

Installation Guide

5.When the driver installation is complete, the final page of the Wizard appears. Click Finish to complete the LecNet2™ USB driver installation.

Installation of Additional Units (or LecNet 2™ devices)

The Windows XP operating system regards all Lecnet2™ devices as separate USB devices because each has a unique serial number. Because of this, Windows XP will want to install the USB driver every time it encounters a LecNet2™ device whose serial number it does not recognize. However, if the Lec- Net2™ USB driver has already been installed at least once before on the computer system, the process is simplified because the LecNet2™ installation disk is not required.

Use the following procedure if the LecNet2™ USB driver was previously installed on the computer system.

1.On the first page of the Wizard, select Install the software automatically (Recommended) and click Next> to continue.

2.Windows discovers the previously installed USB driver. It is likely that a dialog will open warning you that the driver has not passed Windows Logo Testing. Click Continue Anyway.

3.When the driver installation is complete, the final page of the Wizard appears. Click Finish. It is now possible to connect to the LecNet2™ device.

Rio Rancho, NM

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents DMTH4 DMTH4 LECTROSONICS, INC Important Safety Instructions Table of Contents Unpacking the unit IntroductionRear Panel Controls and FeaturesFront Panel Audio Connections Hardware InstallationInstalling the DM system into a rack CablesProgrammable Outputs Audio Outputs AUX and CodecTelephone Line Jack Programmable InputsExpansion I/O ports Codec and TEL Remote Control PortsUSB driver installation Windows XP Installing LecNet2 Software and USB DriverInstalling LecNet2 Software Installing the LecNet2 USB DriverInstallation of Additional Units or LecNet 2 devices USB Driver Installation Windows Control System Interconnections Basic System SetupInitial Setup Using the DMTH4 Control Panel to Change Master/Slave Mode Master/Slave ConfigurationInitial Setup Hints DMTH4 Example Teleconferencing SetupSetting up the DM1624 Expansion Matrix Setting up the DMTH4 Main MatrixSetting up the DM1624 Main Matrix Setting up the DMTH4 Output Source Multiplexer Making a Phone Call Make a Telephone Call Using a Telephone SetMake a Telephone Call Using the Activity Tab Using the Touch Tone PadUse the Phone Book Use the Type the number to dial boxConnecting to the Codec Interface using the Activity Tab FCC Part 15 Compliance FCC Part 68 ComplianceInstallation Guide Rio Rancho, NM Limited ONE Year Warranty
Top Page Image Contents