Crestron electronic DMTH4 quick start Limited ONE Year Warranty

Page 24

LIMITED ONE YEAR WARRANTY

The equipment is warranted for one year from date of purchase against defects in

materials or workmanship provided it was purchased from an authorized dealer. This warranty does not cover equipment which has been abused or damaged by careless handling or shipping. This warranty does not apply to used or demonstrator equipment.

Should any defect develop, Lectrosonics, Inc. will, at our option, repair or replace any defective parts without charge for either parts or labor. If Lectrosonics, Inc. cannot correct the defect in your equipment, it will be replaced at no charge with a similar new item. Lectrosonics, Inc. will pay for the cost of returning your equipment to you.

This warranty applies only to items returned to Lectrosonics, Inc. or an authorized dealer, shipping costs prepaid, within one year from the date of purchase.

This Limited Warranty is governed by the laws of the State of New Mexico. It states the entire liablility of Lectrosonics Inc. and the entire remedy of the purchaser for any breach of warranty as outlined above. NEITHER LECTROSONICS, INC. NOR ANYONE INVOLVED IN THE PRODUCTION OR DELIVERY OF THE EQUIPMENT SHALL BE LIABLE FOR ANY INDIRECT, SPECIAL, PUNITIVE, CONSEQUENTIAL, OR INCIDENTAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THIS EQUIPMENT EVEN IF LECTROSONICS, INC. HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN NO EVENT SHALL THE LIABILITY OF LECTROSONICS, INC. EXCEED THE PURCHASE PRICE OF ANY DEFECTIVE EQUIPMENT.

This warranty gives you specific legal rights. You may have additional legal rights which vary from state to state.

581 Laser Road NE • Rio Rancho, NM 87124 USA • www.lectrosonics.com

 

(505) 892-4501 • (800) 821-1121 • fax (505) 892-6243 • sales@lectrosonics.com

2 December, 2005

Image 24
Contents DMTH4 DMTH4 LECTROSONICS, INC Important Safety Instructions Table of Contents Introduction Unpacking the unitControls and Features Front PanelRear Panel Hardware Installation Installing the DM system into a rackCables Audio ConnectionsAudio Outputs AUX and Codec Telephone Line JackProgrammable Inputs Programmable OutputsCodec and TEL Remote Control Ports Expansion I/O portsInstalling LecNet2 Software and USB Driver Installing LecNet2 SoftwareInstalling the LecNet2 USB Driver USB driver installation Windows XPInstallation of Additional Units or LecNet 2 devices USB Driver Installation Windows Basic System Setup Initial SetupControl System Interconnections Master/Slave Configuration Using the DMTH4 Control Panel to Change Master/Slave ModeInitial Setup Hints Example Teleconferencing Setup DMTH4Setting up the DMTH4 Main Matrix Setting up the DM1624 Main MatrixSetting up the DM1624 Expansion Matrix Setting up the DMTH4 Output Source Multiplexer Make a Telephone Call Using a Telephone Set Make a Telephone Call Using the Activity TabUsing the Touch Tone Pad Making a Phone CallUse the Type the number to dial box Use the Phone BookConnecting to the Codec Interface using the Activity Tab FCC Part 68 Compliance FCC Part 15 ComplianceInstallation Guide Rio Rancho, NM Limited ONE Year Warranty