Crestron electronic DMTH4 quick start USB Driver Installation Windows

Page 12

DMTH4

USB Driver Installation (Windows 2000)

First Time Installation

When a LecNet2™ device is connected to a comptuer system running the Windows® 2000 operating system for the very first time, the Windows Found New Hard- ware Wizard automatically opens. (Dm1624 shown for illustrative purposes only.)

Use the following procedure to install the LecNet2™ USB driver using the Wizard.

1.Connect a cable between the DM processor USB port and the computer system. Place the LecNet2™ Installation Disk in the computer system’s CD-ROM drive and click Next> to con- tinue.

2.Select "Search for a suitable driver for my device (recommended)" and click Next> to continue.

3.Check "CD-ROM drives" then click Next> to search the LecNet2™ CD for the USB driver.

4.When it is found, the LecNet2™ device name will be displayed. Click Next> to install the driver.

5.When the driver installation is complete, the final page of the Wizard appears. Click Finish. It is now possible to connect to the LecNet2™ device.

12	LECTROSONICS, INC.

Image 12

Contents DMTH4 DMTH4 LECTROSONICS, INC Important Safety Instructions Table of Contents Introduction Unpacking the unitControls and Features Front PanelRear Panel Hardware Installation Installing the DM system into a rackCables Audio ConnectionsAudio Outputs AUX and Codec Telephone Line JackProgrammable Inputs Programmable OutputsCodec and TEL Remote Control Ports Expansion I/O portsInstalling LecNet2 Software and USB Driver Installing LecNet2 SoftwareInstalling the LecNet2 USB Driver USB driver installation Windows XPInstallation of Additional Units or LecNet 2 devices USB Driver Installation Windows Basic System Setup Initial SetupControl System Interconnections Master/Slave Configuration Using the DMTH4 Control Panel to Change Master/Slave ModeInitial Setup Hints Example Teleconferencing Setup DMTH4Setting up the DMTH4 Main Matrix Setting up the DM1624 Main MatrixSetting up the DM1624 Expansion Matrix Setting up the DMTH4 Output Source Multiplexer Make a Telephone Call Using a Telephone Set Make a Telephone Call Using the Activity TabUsing the Touch Tone Pad Making a Phone CallUse the Type the number to dial box Use the Phone BookConnecting to the Codec Interface using the Activity Tab FCC Part 68 Compliance FCC Part 15 ComplianceInstallation Guide Rio Rancho, NM Limited ONE Year Warranty