Furuno FS-1503 manual Changing System Settings, System Setup, Customizing by User

Page 26

3.CHANGING SYSTEM SETTINGS

3.1System Setup

1.While pressing and holding down the [CH] key, turn on the power. Release the [CH] key when “MEMO” appears on the display.

System code

Setting value

MEMO

Figure 3-1 System setting selection screen

2.Turn the [FREQ/CH] control to select a desired code number.

3.Press the [CH] key, enter desired setting by a numeric key, then press the [ENT] key.

4.To change setting for another code, repeat steps 2 and 3.

5.Reset the power.

3.2 Customizing by User

The operator can customize several system settings. The table below shows the system codes and their function, setting range and factory setting.

Note: FURUNO Electric Company will assume no responsibility for the inconvenience or disturbance to communications due to inadequate or unlawful presetting of this equipment.

Code	Function, Setting
9942	Key beep ON/OFF
	A beep sounds when a keying sequence is correctly executed. You may turn
	the beep on or off.
	Factory setting: ON
9943	Noise blanker ON/OFF
	The noise blanker cancels unwanted noise.
	Factory setting: ON

3-1

Image 26

Contents Page Page Safety Instructions Table of Contents Features IntroductionSystem Configuration OperationKeys Transceiver Unit DescriptionRotary controls Indications ALMTurning the Loudspeaker On/Off Turning the Power On/OffAdjusting the Backlighting Turning the Squelch On/OffSelecting Frequency Turning AGC on/offTx frequency Direct frequency entryRx frequency Paired Rx/Tx frequencyUser channels J3EITU telephony channels SSB Sample displays of ITU telephony channelITU Telex channels TLXTransmitting Tuning the antennaDisplaying Station Name Reducing transmitter power Using the microphoneMonitoring transceiver output power Distress Call on 2182 kHzDistress frequencies Distress calls and Distress messageReceiving Adjusting RF gainClarifier adjustment MeterNoise blanker NB Receiving AM broadcasting stationsSquelch control User channels Frequency ScanChannel scan ITU channels 12 Sample scan screenFrequency Sweep MIF Commands MIF commands applicable to the FS-1503Furuno Nbdp Terminal DP-5/DP-6 Operation of Optional EquipmentTelex Communication Priority Remote Station RB-500 requires optional Remote-B BoardIntercom Communication on 2182 kHzCustomizing by User Changing System SettingsSystem Setup Scan/sweep-stop signal level Writing User Channels Testing the transmitter with a dummy antenna MaintenanceAural testing Weekly ChecksDiagnostic Test Sequence of diagnostic testLCD/Keyboard Test & ROM Version No. Confirmation Key and corresponding indicationMaintenance MaintenanceMaintenance con’t Troubleshooting Troubleshooting ListTroubleshooting list con’t Errow Indication Replacing FusesSpecifications GeneralAntenna Coupler Appendix Custom CHANNELS/FREQUENCIESMF band working carrier frequencies ref. US CFR 47 Part MF band SSB working carrier frequencies CH noMHz ITU SSB carrier frequencies ITU RR Appendix ITU CH noFollowing frequencies are factory programmed 12/16 MHz ITU SSB carrier frequencies ITU RR Appendix CH no Ship RX Ship TX Telex Channels MF Band Telex Frequency TableMHz Band ITU Nbdp Telex Frequency Table ITU RR Appendix8001 12001 12/16 MHz Band ITU Nbdp Telex Frequency Table 16111 18/19 MHz Band ITU Nbdp Telex Frequency Table CH NO. Ship RX Ship TX22001 22, 25/26 MHz Band ITU Nbdp Telex Frequency Table Index

Related manuals

Manual 50 pages 63.4 Kb