Furuno FS-1503 manual Writing User Channels

9957	Squelch delay - a delay until the squelch mutes (closes) the receiver after
	the signal has gone.
	(Ex) 9957: 1000 ms
	Squelch closes 1000 ms after the signal has gone.
	Setting range: 500-4000 ms; Factory setting: 1000 ms
9958	Squelch activating frequency
	Setting range: 500-2000 Hz; Factory setting: 1000 Hz

3.3 Writing User Channels

The user channels may write user Tx channels. (Rx channels may also be written where permit- ted.)

1.Turn on the power while pressing the [CH] key. Release the key when MEMO appears.

2.Rotate the [FREQ/CH] control clockwise to display desired channel no. “R” appears (Rx frequency writing mode).

4.Press the [MODE/1] key to select class of emission.

5.Press the [CH] key. Key in Rx frequency with the numeric keys (0-9) and press the [ENT] key. If you are only writing Rx frequency go to step 8.

6.Rotate the [FREQ/CH] control clockwise. “T” appears (Tx frequency writing mode).

7.Enter Tx frequency like you entered Rx frequency.

8.Rotate the [FREQ/CH] control clockwise. If no station name have been written you will see seven dashes. If station name cannot be entered for a particular station, the next channel number appears.

9.Press the [CH] key to enter station name or write over existing name. The cursor appears. A station name may consist of seven characters, hyphens, alphabet, numerics and spaces are available.

10.Operate the [FREQ/CH] control to display character desired and press the [ENT] key. To enter a space or shift the cursor press the [ENT] key. To erase station name, press [CH], [0] and [ENT]. When seven characters are entered, the cursor disappears.

11.Turn off the power to register channels.

3-3