Configuring Intercoms
If you need to change other options on the intercoms, make sure that you check menu View Advanced. Refer to Advanced Configuration for details.
Intercom Configuration - Direct Mode
Configuring two intercoms in
This procedure configures two Intercoms to connect to each other. This connection can be on a LAN, WAN or across the Internet.
To configure intercoms to connect to TalkMaster™, please see Intercom Configuration - TalkMaster Clients.
From the main TalkMaster™ screen, select the menu Admin Configure Intercoms. The system will scan the local network segment using a UDP Broadcast to find all IP Intercoms. New Intercoms will show up with IP addresses of zero. The Icom ID displayed on the
screen will match the ID# printed on the back of the Intercom.
If you have intercoms located in a different network segment, you may not find them since many routers filter out UDP Broadcasts. You can either configure these intercoms on the current network segment prior to installing them on the desired network or you can install a copy of TalkMaster in the other network segment to configure your intercoms. You may also refer to the TalkMaster installation CD for instructions on installing the UBAM™ software which will allow you to configure units across different networks.
Determine which of the two intercoms will be the
37