Aiphone GH series operation manual Precautions

Page 2

PRECAUTIONS

General Prohibitions Prohibition to Dismantle the Unit

Prohibition on Subjecting the Unit to Water

General Precautions

WARNING

(Negligence could result in death or serious injury to people)

1. The unit must be installed and wired by a qualified technician.

2. Do not dismantle or alter the unit. Fire or electric shock could result.

3.Do not connect any non-specified power source to the +, - terminals, and do not install two power supplies in parallel to a single input. Fire, damage to the unit, or system malfunction could result.

4. Keep the unit away from water or any other liquid. Fire or electric shock could result.

5. Do not plug or unplug with wet hands. Electric shock could result.

6.Do not put any metal or paper into the unit through the openings. Fire or electric shock could result.

7.Do not put high pressure on the video-monitor surface. If fractured, injury could result.

8.High voltage is present internally. Do not open the case. Electric shock could result.

CAUTION

(Negligence could result in injury to people or damage to property)

1. Make sure wires are connected properly before plugging the power supply into an electrical outlet.

2.Do not manually hold down hook switch while testing and verifying chime or call tone volume. The chime tone is very loud in earpiece,and could cause hearing damage.

3.Do not install or make any wire terminations while power supply is plugged in. It can cause electrical shock or damage to the unit.

4.Do not install the unit in a location subject to constant vibration or impact. If dropped, injury or unit damage could result.

5. When mounting the unit on wall, install the unit in a convenient location, but not where it could be jarred or bumped. Injury could result.

6. Do not alter or change wall-mounting of the unit. If dropped, it can cause injury.

7. Before turning on power, make sure wires are not crossed or shorted. Fire or electric shock could result.

8.If LCD is punctured, do not allow contact with the liquid crystal inside. Inflammation could result. If necessary, gargle your mouth and clean your eyes or skin with clear water for at least 15 minutes, and consult your doctor.

9. When cleaning outer surface with high-pressure water, be sure that the entrance station will not be subjected to direct water pressure. Damage to the unit could result.

10.To avoid system malfunction, do not install the unit in places;

1.high or extreme cold temperature,

2.subject to moisture or humidity extremes,

3.environmental conditions: dust, oil, chemicals, salt, etc.,

4.constant vibration or impact, and 5. steam or smoke.

11.Do not put anything on or cover the unit with cloth, etc. Fire or unit trouble could result.

12. For DC powered systems, use Aiphone power supply model specified with system. If non-specified product is used, fire or malfunction could result.

GENERAL PRECAUTIONS

1.All the units, except for entrance station, is designed for indoor use only. Do not use outdoors.

2.The unit will be inoperative during a power outage.

3.In areas where broadcasting station antennas are close by, the intercom system may be affected by radio frequency interference.

4.Keep the intercom wires more than 12 inches (30 cm) away from AC 100~240V wiring. AC induced noise and/or unit malfunction could result.

5.Keep the unit more than 1 m away from Radio or TV set.

6.When strong light comes in on the unit's screen, the image looks white or silhouetted. But this is not a unit trouble.

- 2 -

Image 2
Contents GH Series Precautions Names Entrance Station Standard system Wiring System Configurations Standard System Configuration Diagram #1 b Expanded System Configuration Diagram Wiring DistanceUnit Unit Entrance StationCombination Example for Entrance Station Unit Bus Control Unit and OthersResidential Station Security Guard StationMounting Mounting the Entrance StationGH-DA Bus Control Unit and Power Supply Adapter Optional Handset GH-1AD GH-1KDSecurity Guard Station Mounted on Wall Wiring VR1Standard System 2 Station-to-Station Wiring Standard SystemGH-1MD Standard System 2 Homerun Wiring NPNon-polarizedGH-VBX Expanded System External Relay ConnectionEntrance Station Names Entrance Station Names Residential StationGH-10K Residential station GH-1AD, GH-1KDNames Security Guard Station Residential station GH-1MDAdjusting the Camera Angle Entering Names and AddressesMaking Adjustments with the Mounting Gauge Setting up the System Default setting of ∗1111 Programming GH-NSMenu Program Mode GH-NS Setting UP Security Guard Station Select Menu & QuitProgramming GH-MK Menu Program Mode GH-MK Calling a Residential Station 10-1Operations Entrance Station Calling the Security Guard Station 10-210-3 Door ReleaseCall from the Doorbell Button Individual Entrance Door 11-1 11-2Responding to a Call Turning on the Entrance Light 11-311-4 Automatic Entry Doctor Call Option 11-511-6 Entrance Monitoring Emergency Alarm11-7 11-8 Responding to a Call from an Entrance Station 12-112-2 Responding to a Call from a Residential Station12-3 12-4 Calling a Entrance StationCalling Another Security Guard Station 12-512-6 Emergency Call12-9 12-712-8 Specifications Technical Precautions SpecificationsTechnical precautions Warranty