Aiphone 0207 AIC operation manual Bus Control Unit and Power Supply

3-4

1

[1]

[2]

GH-BC

GH-VBC

[3]

[4]

ON

OFF

3

[1]

[2]

GH-4Z

5

[1]

GH-BCX/A

GH-VBX

6

+ –

+ –

PS-2410LC

[1]

PS-2410DIN

2

	[1]
	[6]
[2]	GH-BC
	GH-VBC

[5]

4

[1]

[6]

GH-4Z

[2]

[5]

[1]

[5]

+ –

PS-2410LD

Bus Control Unit and Power Supply

[1]Din rail (W-DIN11)

[2]Screw hole

[3]POWER switch

[4]Power On LED (green)

[5]Lock release lever

[6]Wall mounting screws (x2)

1.Mount GH-BC and GH-VBC to the Din rail. Click unit into place.

∗To remove GH-BC and GH-VBC, pull the lock release lever down.

∗If there is a problem with the system, check the power supply wiring. Turn off the GH-BC and GH-VBC power switch and then turn the switch back on after four seconds. This will reset the entire system.

2.Mount GH-BC and GH-VBC directly to the wall surface.

3.Mount GH-4Z to the Din rail.

∗To remove GH-4Z, pull the lock release lever down.

4. Mount GH-4Z directly to the wall surface.

5. Mount GH-BCX/A and GH-VBX to the Din rail. To remove

GH-BCX/A and GH-VBX, pull the lock release lever down. 1. GH-BCX/A and GH-VBX cannot be mounted directly to

the wall surface.

2. The length of the connecting cable between the GH-BCX/A and GH-VBX is 40 cm (15-3/4"). Therefore, mount the GH- BCX/A and GH-VBX adjacent to each other.

6. Power supply PS-2410LC, PS-2410LD, PS-2410DIN Red: +

Black: -

- 13 -