Philips CD285 Answer a call, Adjust the earpiece volume, Mute the microphone, Make a second call

Page 12

Answer a call

When the phone rings, press / to answer the call.

Warning

•• When the handset rings or when the handsfree is activated, keep the handset away from your ear to avoid ear damage.

Note

•• The caller ID service is available if you have registered to the caller ID service with your service provider.

Tip

•• When there is a missed call, the handset displays a notification message.

Turn off the ringer for all incoming calls

When the phone rings, press .

Adjust the earpiece volume

Press / to adjust the volume during a call. »» The earpiece volume is adjusted and the phone is back to the call screen.

Mute the microphone

1 Press during a call.

»» The handset displays [Mute on].

»» The caller cannot hear you, but you can still hear his voice.

2 Press again to unmute the microphone. »» You can now communicate with the

caller.

Turn the speaker on or off

Press .

Make a second call

Note

•• This service is network dependent.

1 Press during a call.

»» The first call is put on hold.

2 Dial the second number.

»» The number displayed on the screen is dialed out.

Answer a second call

Note

•• This service is network dependent.

When there is a periodical beep to notify you of an incoming call, you can answer the call in these ways:

1 Press and to answer the call. »» The first call is put on hold, and you

are now connected to the second call.

2 Press and to end the current call and answer the first call.

12EN

Image 12
Contents Register your product and get support at CD280 CD285EC Declaration of Conformity Contents Power requirements Voltages, as defined in the standard EN 60950To avoid damage or malfunction What is in the box Handset Charger Power adapterCongratulations on your purchase and welcome to Philips Overview of the phone EarpieceOn the handset screen Directly above the keyIt flashes when there is a new voice message It displays when you ncrease and decrease the volumeDisplay icons Get started Connect the base stationInstall the handset Set the date and timeCharge the handset Press OK to confirmCheck the battery level What is standby mode?Check the signal strength Switch your handset On/OffCalls Make a callAdjust the earpiece volume Answer a callMute the microphone Turn the speaker on or offToggle between two calls Make a conference call with the external callersYou can toggle your calls in these ways Press and or Press , then orMake a call to another handset Transfer a callMake a conference call While you are on the phoneDuring an external call During the conference callText and numbers Enter text and numbersSwitch between the upper case and lower case Phone settings Sound settingsName the handset Set the display languageECO mode »» ECO is displayed in standby modeSet the docking tone Set the sound profileAlarm clock Set the alarmTurn off the alarm When the alarm ringsServices Dial modeAuto conference Select the recall durationManage the area code Network typeRestore default settings Register the handsetsUnregister the handsets Default settings Receiver volume VolumeLanguage Country dependent Handset name LevelTechnical data DisplayFrequently asked questions Handset does not ringDeclaration of conformity Compliance with EMFDisposal of your old product and batteries Manufacturer’s instructionsPage 1999/5/EC Richtlijn 1999/5/EGDirective 1999/5/CE Som framgår av direktiv 1999/5/EG0168