Philips CD285, CD280 user manual Power requirements, Voltages, as defined in the standard EN 60950

Page 4

1Important safety instructions

Power requirements

This product requires an electrical supply of 100-240 volts AC. In case of power failure, the communication can be lost.

The voltage on the network is classified as TNV-3 (Telecommunication Network

Voltages), as defined in the standard EN

60950.

Warning

•• The Electrical network is classified as hazardous. The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible.

To avoid damage or malfunction

Caution

•• Use only the power supply listed in the user instructions.

•• Use only the batteries listed in the user instructions.

•• Do not allow the charging contacts or the battery to come into contact with metal objects.

•• Do not open the handset, base station or charger as you could be exposed to high voltages.

•• Do not allow the product to come into contact with liquids.

•• Risk of explosion if battery is replaced by an incorrect type.

•• Dispose of used batteries according to the instructions.

•• Always use the cables provided with the product.

•• For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily accessible.

•• Handsfree activation could suddenly increase the volume in the earpiece to a very high level: make sure the handset is not too close to your ear.

•• This equipment is not designed to make emergency calls when the power fails. An alternative has to be made available to allow emergency calls.

•• Do not expose the phone to excessive heat caused by heating equipment or direct sunlight.

•• Do not drop your phone or allow objects to fall on your phone.

•• Do not use any cleaning agents containing alcohol, ammonia, benzene, or abrasives as these may harm the set.

•• Do not use the product in places where there are explosive hazards.

•• Do not let small metal objects come into contact with the product. This can deteriorate audio quality and damage the product.

•• Active mobile phones in the vicinity may cause interference.

•• Metallic objects may be retained if placed near or on the handset receiver.

About operating and storage temperatures

Operate in a place where temperature is always between 0°C to +35°C (32°F to 95°F).

Store in a place where temperature is always between -20°C and +45°C (-4° F to 113° F).

Battery life may be shortened in low temperature conditions.

4EN

Image 4
Contents Register your product and get support at CD280 CD285EC Declaration of Conformity Contents Voltages, as defined in the standard EN 60950 Power requirementsTo avoid damage or malfunction Handset Charger Power adapter What is in the boxCongratulations on your purchase and welcome to Philips Overview of the phone EarpieceOn the handset screen Directly above the keyIt displays when you ncrease and decrease the volume It flashes when there is a new voice messageDisplay icons Get started Connect the base stationInstall the handset Set the date and timeCharge the handset Press OK to confirmCheck the battery level What is standby mode?Check the signal strength Switch your handset On/OffCalls Make a callAdjust the earpiece volume Answer a callMute the microphone Turn the speaker on or offToggle between two calls Make a conference call with the external callersYou can toggle your calls in these ways Press and or Press , then orMake a call to another handset Transfer a callMake a conference call While you are on the phoneDuring an external call During the conference callText and numbers Enter text and numbersSwitch between the upper case and lower case Phone settings Sound settingsName the handset Set the display languageECO mode »» ECO is displayed in standby modeSet the docking tone Set the sound profileAlarm clock Set the alarmTurn off the alarm When the alarm ringsServices Dial modeAuto conference Select the recall durationManage the area code Network typeRegister the handsets Restore default settingsUnregister the handsets Default settings Receiver volume VolumeLanguage Country dependent Handset name LevelTechnical data DisplayFrequently asked questions Handset does not ringDeclaration of conformity Compliance with EMFDisposal of your old product and batteries Manufacturer’s instructionsPage 1999/5/EC Richtlijn 1999/5/EGDirective 1999/5/CE Som framgår av direktiv 1999/5/EG0168