Philips CD280 Install the handset, Set the date and time, Charge the handset, Press OK to confirm

Page 9

Install the handset

Caution

•• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.

•• Use only the supplied batteries.

•• Risk of decreased battery life! Never mix different brands or types of batteries.

Warning

•• Check the battery polarity when inserting in the battery compartment. Incorrect polarity may damage the product.

The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging.

Set the date and time

Tip	Eng l i s h

•• To set the date and time later, press [Back] to skip this setting.

1 Select [Menu] > [Phone setup] > [Date & time], then press [OK] to confirm.

2 Press the numeric buttons to enter the date, then press [OK] to confirm.

»» The time setting menu is displayed on the handset.

3 Press the numeric buttons to enter the time.

Note

•• If the time is in 12-hour format, press / to select [AM] or [PM].

4 Press [OK] to confirm.

Charge the handset

Place the handset on the charging cradle to charge the handset.When the handset is placed correctly on the charging cradle, your hear a docking sound.

»» The handset starts charging.

Note

•• Charge the batteries for 8 hours before first use.

•• If the handset becomes warm when the batteries are being charged, it is normal.

Your phone is now ready to use.

EN 9

Image 9

Contents CD280 CD285 Register your product and get support atEC Declaration of Conformity Contents Power requirements Voltages, as defined in the standard EN 60950To avoid damage or malfunction What is in the box Handset Charger Power adapterCongratulations on your purchase and welcome to Philips Earpiece Overview of the phoneOn the handset screen Directly above the keyIt flashes when there is a new voice message It displays when you ncrease and decrease the volumeDisplay icons Connect the base station Get startedSet the date and time Install the handsetCharge the handset Press OK to confirmWhat is standby mode? Check the battery levelCheck the signal strength Switch your handset On/OffMake a call CallsAnswer a call Adjust the earpiece volumeMute the microphone Turn the speaker on or offMake a conference call with the external callers Toggle between two callsYou can toggle your calls in these ways Press and or Press , then orTransfer a call Make a call to another handsetMake a conference call While you are on the phoneDuring the conference call During an external callEnter text and numbers Text and numbersSwitch between the upper case and lower case Sound settings Phone settingsName the handset Set the display language»» ECO is displayed in standby mode ECO modeSet the docking tone Set the sound profileSet the alarm Alarm clockTurn off the alarm When the alarm ringsDial mode ServicesAuto conference Select the recall durationNetwork type Manage the area codeRestore default settings Register the handsetsUnregister the handsets Receiver volume Volume Default settingsLanguage Country dependent Handset name LevelDisplay Technical dataHandset does not ring Frequently asked questionsCompliance with EMF Declaration of conformityDisposal of your old product and batteries Manufacturer’s instructionsPage Richtlijn 1999/5/EG 1999/5/ECDirective 1999/5/CE Som framgår av direktiv 1999/5/EG0168