Installation Guide - Overview
Table 11 - Install HC900 Controller Components
Step | Procedure | Comments/References |
1 | Mount the Controller Rack | For dimensions of the pattern for drilling holes, refer to the |
| in the enclosure as follows. | diagram below. |
| • Using the diagram |
|
| below as a guide, mark |
|
| the locations for rack |
|
| mounting in the |
|
| enclosure for the top |
|
| holes in the rack. |
|
| (See CAUTION and |
|
| Note at right.) |
|
| • Drill and tap for # 10 (or |
|
| M4) screws. |
|
| • Start the mounting |
|
| screws (supplied by the |
|
| user) in the drilled |
|
| holes. |
|
| • Hang the Rack on the |
|
| screws at the top. | CAUTION: |
| • Mark the locations for | |
|
| |
| the bottom screws. | When drilling holes, prevent metal flakes from falling into |
| (See CAUTION at | the rack, or onto any surface within the electrical cabinet. |
|
| |
| right.) | Note: Always mount racks as shown above. That is, never |
|
| |
| • Drill and tap for # 10 (or | mount vertically, or with backplane horizontal. |
| M4) screws. |
|
| • Remove the rack from |
|
| the enclosure. |
|
52 | HC900 Hybrid Controller Installation and User Guide | Revision 5 |
|
| 9/03 |