Communications Installation - Connecting the HC900 Controller to a PC with the Hybrid Control Designer Software
Step | Action |
8Key in the following command string: AT Y0
Then, press the ENTER key.
The modem should respond with OK.
9Key in the following command string: AT &B1
Then, press the ENTER key.
The modem should respond with OK.
10
AT E0 Q1 &W0
The Modem will not respond.
11Power down the modem and disconnect it from the PC.
12Set the modem switches to the following:
Switch | Setting | Position | Function |
1 | ON | DOWN | Modem ignores DTR (Override) |
|
|
|
|
2 | OFF | UP | Verbal (word) results |
3 | OFF | UP | Suppresses result codes |
4 | ON | DOWN | Suppresses echo |
5 | OFF | UP | Modem answers on first ring |
|
|
|
|
6 | ON | DOWN | CD always ON (Override) |
|
|
|
|
7 | OFF | UP | Loads |
|
|
| nonvolatile memory (NVRAM) |
8 | OFF | UP | Disables command recognition (dumb mode) |
13Connect the modem to the
14Connect the modem to a telephone jack.
15Power up the modem and the HC900 Controller.
16On a remote computer, run Hybrid Control Designer software.
17Set up Hybrid Control Designer software to dial the HC900 Controller.
18Verify that communications is established with the remote HC900 Controller.
96 | HC900 Hybrid Controller Installation and User Guide | Revision 5 |
|
| 9/03 |