Philips D750 manual Brokering, Conference, Parking, Call list

20 A – Telephone operation: 3 Telephoning: During a call

3.4Brokering

You can set up a 2nd call during a telephone call so that you can talk alternately with both of the other parties (= brokering). During brokering, the party that you are not talking to at that moment is put ”on hold”. He/she cannot hear the other conversation.

You are in the middle of a telephone call:

- Dial telephone number - When you are connected with

the 2nd party: By repeatedly pressing the consultation key, you

can switch between the two connections.

End brokering: press disconnect key

You are reconnected with the party you previously put on hold

3.5Conference

You can set up a 2nd call during a telephone call so that you can subsequently talk with both parties at the same time. For this, the ISDN function ”three-party conference” must be available for your line.

You are in the middle of a telephone call:

-	Dial tel. number -	When you are connected with the 2nd
party:		-
end conference:

Note	If one of the parties you are talking to ends the call, you remain connected
	with the other one.

3.6Parking

You can “park” a call. The connection still remains.

There are two ways to resume the call:

1.You pull the plug of the telephone at the telephone connection socket in order to plug it into another socket (of the same multi-device line). You can then resume the call there.

2.You can also resume the call at another SmartLine D750 operating at the same ISDN line.

A – Telephone operation: 4 Comfort functions		21
Parking a call	)	-
You are in the middle of a call (

You can input a code (maximum 2 digits) for the connection .

The input is, however, not necessary.

Confirm storage

You can resume the call connection within 3 minutes.

Resuming the call	)	–
– (

Only if parking was performed using a code number:

Enter code (maximum 2 digits) ,

Confirm storage

Notes

The parking period must not exceed 3 minutes.

Resumption of the call can also be performed without previously lifting the handset. The unit then automatically switches hands-free operation on.

4.1Call list

Certain calls with transfer of the telephone number can be automatically stored in the call list:

1.Not accepted calls (also applies when the capacity of the answering device has been reached).

2.Camp-on busy calls which were refused.

A maximum of 10 calls are stored along with telephone number and the message sent. With more than 10 calls the oldest entry is replaced by the next incoming call.

	Viewing the call list / deleting an entry
	If list entries are available,				is displayed in idle condition:
Viewing the list
	(	)	-	- display of the last caller
		select input
		read	: date, time, number of calls
			Select display of a Message (if present), or called MSN
			Confirm
Deleting an entry		Or:		-	Confirm erase