Philips D750 manual Messages, Barriers

28 A – Telephone operation: 4 Comfort functions

4.6Messages

Message texts can be sent between telephones connected to the ISDN network. The function can only be used if it is available for your ISDN line! Additionally, this ISDN service must be activated at your SmartLine D750: See part A, section 5.12.

Receiving	A received message is shown in the display after ending the call. In the
messages	case of texts longer than 24 characters, you can view ”more” of it in the
	display by pressing the O.K. key.

Sending	-	-
a message
	Select message -	View more of the message -

If the selection described above is performed during a call, the text is transferred at the end of the call.

A – Telephone operation: 4 Comfort functions 29

4.7Barriers

You can specify the possibilities for outgoing calls and for programming by setting up barriers. You can find out how to restrict incoming calls in the section ”Call filters”.

The setting up of barriers is protected by a PIN (Personal Identification Number).

4.7.1Hot line

With the hot line function activated, only the automatic dialing of one single telephone number is possible (e. g. in an emergency). The telephone num- ber is dialed after lifting the handset and subsequently pressing any key.

Manual dialing is not possible. Telephone number memories cannot be used. The telephone can, however, continue to be called.

The hot line has priority over all other set-up barriers: This means that it is also performed with the dial bar activated, for example.

The message can also be selected before the call. This is then transferred at the next call that you make.

The selection of a text can be deleted again. Deletion of the selection is only offered where a message has been previously selected.

	-	-	-
Leaving	-		–
messages

Entering/ changing the hot line number

-		-
Enter PIN -		-
		-
(	delete a possibly existing hot line number)
Input tel. number -		store input

for callers	-	/
	Switch on or off -
		-
	Select message -		View more of the message -
Changing	Existing message texts can be changed (maximum length: 32 characters).
message	Entry/ depiction of special characters: e.g. Ä, Ö, Ü =			, , .
texts
	–-	-		-
	Select message -		confirm change
	Delete current text -		enter new text -	Store

Switch on	-	-
hot line
	Enter PIN -	-
	Switch on hot line -	store setting

Hot line is switched on: The corresponding symbol is displayed.

When switching off, the handset must be on hook!

Switch off	-	-	–
hot line
	Enter PIN-
	Switch off hot line -		store setting