Product behaviour
Keypad does not work!
•Unlock your keypad: Long press *in idle mode.
The handset warms up when making a long call!
•This is a normal behavior. The handset consumes energy while calling.
The handset cannot be registered to the base station!
•Maximum number of handsets (6) has been reached. To register a new handset, unregister an existing handset.
•Remove and replace the handset batteries.
•Try again by disconnecting and connecting the base station power supply and follow the procedure to register a handset.
•Make sure that you have entered the correct PIN code. If you have not changed it, by default it is 0000.
Caller’s number is not displayed!
•Service is not activated: Check your subscription with your network operator.
Poor audio quality and the antenna icon 
is blinking!
•The indoor and outdoor range of the phone is up to 50 metres and 300 metres respectively.
When the handset moves beyond the
operation range, the antenna icon 
will blink.
My handset keeps going into idle mode!
•If there are no key presses for 30 seconds, the handset will automatically return to idle mode. It will also return to idle mode automatically when you place the handset back on the base station.
Phonebook entry cannot be stored and MEMORY FULL is displayed!
•Delete an entry to free memory before saving your contact again.
The copy from my mobile phone SIM card to SE745 is not complete!
•Only phonebook entries from your mobile phone SIM card will be transferred. If you have phonebook entries on your mobile phone memory, transfer them to your mobile phone SIM card before transferring to your SE745.
The Master PIN code is wrong!
•The default master PIN is 0000.
•If it has been changed before, and you cannot remember the new one, reset the handset to revert to the default master PIN code (see “Reset Unit” on page 32).
The answering machine does not record messages!
•Memory is full: Delete your old messages.
•The ANSWER ONLY mode has been activated. Deactivate ANSWER ONLY and activate ANSWER & REC mode (see “Set the Answer mode” on page 37).
Remote control access does not work!
•Activate Remote Control Access (see “Remote Control Access” on page 38).
The phone hangs up during remote access!
•You have not changed change your Master PIN code. The remote access code cannot be 0000. Change your Master PIN code (see “Change Master PIN” on page 32).
•You have taken more than 8 seconds to enter the Master PIN code. Enter the code again within 8 seconds.
Answering machine stops before the recording is finished!
• Memory is full: Delete your old messages.
Frequently asked questions | 43 |