Operating additional units
Additional handsets
Up to 6 handsets can be registered to a single base unit. Additional handsets will give you the freedom to, for example, have an intercom call with another handset while a third handset is on an outside call. See page 4 for information on ordering additional handsets.
Important:
LThe additional handset model recommended for use with this unit is noted on page 4. If other model handset is used, certain operations (handset settings, base unit settings, etc.) may not be available.
LThe included handset can be registered to only 1 base unit. You can use additional handsets with this base unit, but you cannot use the included handset with another base unit unless you first cancel the base unit from the included handset’s memory.
Registering a handset to a base unit
To register an additional handset to a base unit (easy registration)
The included handset and base unit are preregistered. After purchasing an additional handset, register it to the base unit. Ensure that the additional handset is switched on. If it is not on, press and hold {ih} for few seconds to turn the handset on.
1Lift the additional handset and press {ih} to put the handset in standby mode.
2Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds.
3Place the additional handset on the base unit. The registration tone continues to sound. With the handset still on the base unit, wait until a confirmation tone sounds and w stops flashing.
Note:
LIf an error tone sounds, or if w is still flashing, register the handset manually (manual registration; page 31).
LIf all registered handsets start ringing in step 2, press {x} to stop. Start again from step 1.
LCharge the batteries of your additional handset for about 7 hours before initial use.
Manual registration
You can register a handset to a base unit manually using the following method.
1Press {j/OK}.
2Select “Handset Setup”, then press
{>}.
3Select “Registration”, then press {>} 2 times.
LIf “Memory Full” is displayed, the handset is already registered to a base unit. You can cancel the base unit from the handset’s memory if necessary (page 32).
4Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds.
LIf all registered handsets start ringing, press {x} to stop, then repeat this step.
LAfter pressing {x}, the rest of this procedure must be completed within 1 minute.
31