5Wait until “Enter Base PIN” is displayed, then enter “0000” (default base unit PIN), then press {j/OK}.
LIf you changed the PIN, enter it (page 27).
LWhen the handset has been registered successfully, w will stop flashing. If keytones are turned on (page 22), a confirmation tone will be heard.
Cancelling a handset
A maximum of 6 handsets can be registered to a base unit. A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This will allow the base unit to “forget” the handset.
1Press {j/OK}.
2Select “Base Unit Setup”, then press {>}.
3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page
27).
4Enter “335”.
5Select “Cancel Handset”, then press
{>}.
LThe numbers of all handsets registered to the base unit are displayed.
6Select the handset(s) you want to cancel, by pressing the desired handset number.
LThe selected handset number(s) will flash.
LTo cancel a selected handset number, press the number again. The number will stop flashing.
7Press {j/OK}.
8Select “Yes”, then press {>}.
9Press {ih}.
Cancelling a base unit
A handset can cancel a base unit that it is registered to. This allows the handset to “forget” the base unit.
1Press {j/OK}.
2Select “Handset Setup”, then press
{>}.
3Select “Registration”, then press
{>}.
4Enter “335”.
5Select “Cancel Base”, then press
{>}.
6Enter “0000” (default handset PIN).
LIf you changed the PIN, enter it (page 22).
7Select “Yes”, then press {>}.
8Press {ih}.
Note:
LIf you cancel the base unit from the handset’s memory, you cannot use the handset to make calls or perform other operations. To use the handset again, you must first register it to a base unit (page 31).
Increasing the range of the base unit
You can increase the range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 4. Consult your Panasonic dealer for details.
Important:
LBefore registering the repeater to this base unit, you must turn the repeater mode on.
Turning the repeater mode on/off
1Press {j/OK}.
2Select “Base Unit Setup”, then press {>}.
32