Panasonic kx-tg1805al Troubleshooting, Initial settings, Problem Cause & solution

Page 37

TG1805AL(e-e).book Page 37 Thursday, March 17, 2005 9:37 AM

Useful Information

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.

Initial settings

Problem	Cause & solution
w is flashing.	LThe handset is not registered to the base unit.
	Register it (page 31).
	LThe handset is too far from the base unit. Move
	closer.
	LThe AC adaptor is not connected. Check the
	connections.
The handset display is blank.	LThe handset is not turned on. Turn the power on
	(page 12).
The handset will not turn on.	LMake sure that the batteries are installed correctly
	(page 11).
	LFully charge the batteries (page 11).
	LClean the charge contact and charge again (page
	11).

37

Image 37

Contents Model No. KX-TG1805AL Introduction Making/Answering Calls Included accessories Accessory informationAdditional/replacement accessories Model No DescriptionImportant information Battery cautionGeneral EnvironmentTG1805ALe-e.book Page 6 Thursday, March 17, 2005 937 AM Instructions to customer InstallationService difficulties Controls Controls and displaysHandset Charge contact Phonebook Talk Navigator key Base unit Charge contactDisplays ConnectionsDisplay icons Display Meaning IconBattery charge Battery installationBattery strength Battery icon Turning the power on/off Battery replacementSetting the date and time Example 330 PM Making calls Redial featureAnswering calls Other featuresTo adjust the ringer volume when an outside call comes Auto talk featureHandset locator Adding entries to the phonebook Using the phonebookFinding and calling a phonebook entry Editing entries in the phonebookChain dial Handset settings Sub-menu Default setting Menu Guide to handset settingsNight mode Ringer setupRinger volume Changing ringtonesCall options Display setupOther options Resetting the handset to its default settingsTurning auto talk on/off Turning keytones on/offTG1805ALe-e.book Page 23 Thursday, March 17, 2005 937 AM Base unit Sub-menu Default setting Settings menu Guide to base unit settingsNight mode Changing the recall time Setting pause lengthStoring/changing emergency numbers Selecting area codes to be deleted automaticallyChanging the base unit PIN Personal Identification Number Setting call restrictionResetting the base unit to its default settings Caller list Using Caller ID serviceCall waiting and Caller ID compatible Viewing the caller list and calling backEditing a caller’s phone number before calling back Voice mail serviceErasing caller information Storing caller information into the phonebookRegistering a handset to a base unit Operating additional unitsAdditional handsets Manual registrationCancelling a base unit Cancelling a handsetTurning the repeater mode on/off Increasing the range of the base unitHandset Intercom between handsets60 mm Screws Wall mountingCharacter entry modes Available character entriesExtended 2 character table O Extended 1 character table NCyrillic character table P Initial settings TroubleshootingProblem Cause & solution Telephone Redial the number manually Specifications PIN IndexTG1805ALe-e.book Page 42 Thursday, March 17, 2005 937 AM TG1805ALe-e.book Page 43 Thursday, March 17, 2005 937 AM Copyright Sales Department Panasonic Australia Pty. Limited