Panasonic KX-TG1810NZ Troubleshooting, Initial settings, Problem Cause & solution

Page 39

Useful Information

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.

Initial settings

Problem	Cause & solution
w is flashing.	LThe handset is not registered to the base unit.
	Register it (page 32).
	LThe handset is too far from the base unit. Move
	closer.
	LThe AC adaptor is not connected. Check the
	connections.

The handset display is blank.	LThe handset is not turned on. Turn the power on
	(page 10).

The handset will not turn on.	LMake sure that the batteries are installed correctly
	(page 9).
	LFully charge the batteries (page 9).
	LClean the charge contact and charge again (page
	9).

39

Image 39

Contents Model No. KX-TG1810NZ Introduction Phonebook category Feature highlightsNight mode PhonebookMaking/Answering Calls Accessory information Included accessoriesAdditional/replacement accessories Environment Battery cautionImportant information GeneralBase unit Charge contact Controls and displaysControls MicrophoneDisplay Meaning Icon ConnectionsDisplays Display iconsBattery installation Battery chargeBattery strength Battery icon Battery replacement Turning the power on/offSetting the date and time Example 330 PM Making calls Redial featureOther features Answering calls Finding and calling a phonebook entry Using the phonebookAdding entries to the phonebook CategoriesErasing all entries Erasing entries from the phonebookOne touch dial Erasing an entryCopying all entries Copying phonebook entries to other handsetsChain dial Copying one entryHandset settings Sub-menu Default setting Menu Guide to handset settingsRinger volume Time settingsRinger setup AlarmSetting the ring delay for night mode Night modeSetting the start and end time for night mode Turning night mode on/offChanging the display language Display setupSelecting the standby mode display Selecting categories to bypass night modeOther options Call optionsResetting the handset to its default settings Base unit Sub-menu Default Settings menu Guide to base unit settingsSelect Base Unit Setup, then press Night modeSetting pause length Changing the recall timeStoring/changing emergency numbers Selecting area codes to be deleted automatically Setting call restrictionChanging the base unit PIN Personal Identification Number Resetting the base unit to its default settingsCategory features for Caller ID subscribers Using Caller ID serviceErasing caller information Caller listViewing the caller list and calling back Editing a caller’s phone number before calling backCall minder Additional base units Operating additional unitsRegistering a handset to a base unit Additional handsetsSelecting a base unit Cancelling a handsetIncreasing the range of the base unit Cancelling a base unitTurning the repeater mode on/off Intercom between handsetsTransferring calls between handsets, conference calls 60 mm Screws Hooks Wall mountingCharacter entry modes Available character entriesExtended 1 character table N Extended 2 character table OCyrillic character table P Troubleshooting Initial settingsProblem Cause & solution Telephone Useful Information Specifications PIN IndexCopyright Customer Support Centre Tel. No 272 Sales Department