Panasonic KX-TG1810NZ Battery installation, Battery charge, Battery strength Battery icon

Page 9

Preparation

Battery installation

1Insert the batteries negative (T) terminal first.

2Close the handset cover.

Note:

LUse only rechargeable batteries (page 5).

Battery charge

Place the handset on the base unit for about 7 hours before initial use.

When charging, the battery icon is shown as follows.

When the batteries are fully charged, 5 remains on the display.

Note:

LIt is normal for the handset to feel warm during charging.

LIt takes 7 hours to fully charge the batteries, however, you can use the handset before the batteries are fully charged.

LClean the charge contacts (page 7) of the handset and base unit with a soft, dry cloth once a month, otherwise the batteries may not charge properly. Clean more often if the unit is exposed to grease, dust or high humidity.

Battery strength

Battery icon	Battery strength

5High

6Medium

7Low

When flashing: Needs to be charged.

Note:

LWhen 7flashes, recharge the handset batteries. 7 will continue to flash until the batteries have been charged for at least 15 minutes.

9

Image 9

Contents Model No. KX-TG1810NZ Introduction Night mode Feature highlightsPhonebook Phonebook categoryMaking/Answering Calls Accessory information Included accessoriesAdditional/replacement accessories Important information Battery cautionGeneral EnvironmentControls Controls and displaysMicrophone Base unit Charge contactDisplays ConnectionsDisplay icons Display Meaning IconBattery installation Battery chargeBattery strength Battery icon Battery replacement Turning the power on/offSetting the date and time Example 330 PM Making calls Redial featureOther features Answering calls Adding entries to the phonebook Using the phonebookCategories Finding and calling a phonebook entryOne touch dial Erasing entries from the phonebookErasing an entry Erasing all entriesChain dial Copying phonebook entries to other handsetsCopying one entry Copying all entriesHandset settings Sub-menu Default setting Menu Guide to handset settingsRinger setup Time settingsAlarm Ringer volumeSetting the start and end time for night mode Night modeTurning night mode on/off Setting the ring delay for night modeSelecting the standby mode display Display setupSelecting categories to bypass night mode Changing the display languageOther options Call optionsResetting the handset to its default settings Base unit Sub-menu Default Settings menu Guide to base unit settingsSelect Base Unit Setup, then press Night modeSetting pause length Changing the recall timeStoring/changing emergency numbers Selecting area codes to be deleted automatically Setting call restrictionChanging the base unit PIN Personal Identification Number Resetting the base unit to its default settingsCategory features for Caller ID subscribers Using Caller ID serviceViewing the caller list and calling back Caller listEditing a caller’s phone number before calling back Erasing caller informationCall minder Registering a handset to a base unit Operating additional unitsAdditional handsets Additional base unitsSelecting a base unit Cancelling a handsetTurning the repeater mode on/off Cancelling a base unitIntercom between handsets Increasing the range of the base unitTransferring calls between handsets, conference calls 60 mm Screws Hooks Wall mountingCharacter entry modes Available character entriesExtended 1 character table N Extended 2 character table OCyrillic character table P Troubleshooting Initial settingsProblem Cause & solution Telephone Useful Information Specifications PIN IndexCopyright Customer Support Centre Tel. No 272 Sales Department