Panasonic KX-TG1861NZ operating instructions Error messages, Troubleshooting

Page 33

	Useful Information
Error messages

Error message	Cause & solution
Failed	LPhonebook copy failed. Confirm the other handset
	(the receiver) is in standby mode and try again.
Incomplete	LThe receiver’s phonebook memory is full. Erase the
	unnecessary phonebook entries from the other
	handset (the receiver) and try again.
Memory Full	LThe handset’s phonebook memory is full. Erase
	unnecessary entries (page 16).
You must first subscribe	LYou must subscribe to Caller ID service. Once you
to Caller ID.	receive caller information after subscribing to Caller
	ID service, this message will not be displayed.

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.

Telephone

Problem	Cause & solution
w is flashing.	LThe handset is not registered to the base unit.
	Register it (page 27).
	LThe handset is too far from the base unit. Move
	closer.
	LThe AC adaptor is not connected. Check the
	connections.
	LYou are using the handset or base unit in an area
	with high electrical interference. Place the handset
	and base unit away from interference sources, such
	as antennas and mobile phones.
The handset display is blank.	LThe handset is in screen saver mode (page 10).
	Press {ih} to activate the handset display again.
	LThe handset is not turned on. Turn the power on
	(page 10).
The handset will not turn on.	LMake sure that the batteries are installed correctly
	(page 9).
	LFully charge the batteries (page 9).
	LClean the charge contacts and charge again (page
	9).

33

Image 33

Contents Model No. KX-TG1861NZ Introduction Making/Answering Calls Included accessories Accessory informationImportant information Battery cautionGeneral EnvironmentImportant notice ControlsDisplays Soft key icons Action Key Icon ConnectionsBattery charge If you subscribe to an Adsl serviceLocation Screen saver mode Turning the power on/offTime Settings by Date and time Display languageMaking calls Redial featureEdit and Call i# Erase i #Answering calls Other featuresHandset locator Adding entries to the handset phonebook Handset phonebookCategories Finding and calling a handset phonebook entryEditing entries in the handset phonebook Erasing entries from the handset phonebookOne touch dial Chain dial Handset settings Keytones on/off On Other Options KeytonesAuto Talk Auto talk on/off Off*5Ringer setup Time settingsAlarm Night modeRinger Setup i # Night Mode i # Ring Delay i # Setting the ring delay for night modeSelecting categories to bypass night mode Ringer Setup i # Night Mode i # Select Category i #Repeater Mode Base unit settingsCall Options Recall/Flash Area Code Call Restrict Other Options Base Unit PINCall options Setting call restrictionSelecting area codes to be deleted automatically Call Options i # Area Code i#Category features for handset phonebook Using Caller ID serviceViewing the caller list and calling back Caller listEditing a caller’s phone number before calling back Erasing caller informationCaller ID Service Registering a handset to a base unit Operating additional unitsAdditional handsets Additional base unitsCancelling a handset Cancelling a base unitSelecting a base unit Other Options i # Repeater Mode i # Setting the repeater modeIncreasing the range of the base unit HandsetCopying one entry Copying phonebook entriesCopy i# Copying all entriesWhen the unit displays the character entry screen Characters available in each character entry modeCharacter entry Character entry modesExtended 1 character table N Extended 2 character table OCyrillic character table P Troubleshooting Error messagesProblem Cause & solution LWipe the battery ends S, T and the unit contacts Specifications PIN IndexPage Page Copyright Customer Support Centre Tel. No 272 Sales Department