Programming
Programmable settings
You can customize the unit by programming the following features using the handset. To access the features, there are 2 methods:
–scrolling through the display menus (page 40)
–using the direct commands (page 44)
LMainly the direct command method is used in these operating instructions. LTo change the base unit ringer volume and tone, see page 26.
Programming by scrolling through the display menus
1
2
3
{MENU} (middle soft key)
Press {^}, {V}, {<}, or {>} to select the desired menu. i{SELECT}
LIf there are
Press {^}, {V}, {<}, or {>} to select (. i{SELECT}
Then press {^} or {V} to select “Ringer volume”. i{SELECT}
Press {^} or {V} to select the desired setting.
LThis step may vary depending on the feature being programmed.
4 {SAVE} i{OFF}
Monochrome display models:
LWhen you find “*1” in the following table, refer to the note below.
*1 If you program these settings using one of the handsets, you do not need to program the same item using another handset.
Main menu |
| ||
Voice Mail | Store VM access#*1 | – | |
| VM tone | detect*1 | – |
| Message | alert | – |
Page
52
52
54
40For assistance, please visit http://www.panasonic.com/phonehelp