Troubleshooting
Problem | Cause and Remedy | ||
|
|
|
|
The unit does not work. | • Check the settings (p. 6 – 14). | ||
| • Remove the batteries and reinstall them | ||
| to reset the unit. | ||
|
|
|
|
The unit does not ring. | • The ringer selector is set to OFF. Set to | ||
| HIGH or LOW (p. 11). | ||
|
|
|
|
The display is blank. | • Install new batteries (p. 34). | ||
|
|
|
|
You cannot dial. | • Check that the dialing mode selection is | ||
| correct (p. 10). | ||
| • The dialed number is restricted. To | ||
| cancel, see page 32. | ||
|
|
|
|
The other party suddenly | • [MUTE] may have been pressed during | ||
cannot hear your voice | the conversation. If “ |
| ” is displayed, |
| |||
during a conversation. | press [MUTE]. | ||
|
|
|
|
You cannot program items | • Programming is not possible when the | ||
such as the dialing mode. | handset is off the cradle. | ||
| • Do not pause for over 60 seconds while | ||
| programming. |
You cannot store a name and phone number in memory.
•When using the Call Restriction feature (p. 32), you cannot store an emergency number in the Phone Book List.
•If “PHONEBOOK FULL” is displayed, erase other stored items from the Phone Book List (p. 28).
•Programming is not possible when the handset is off the cradle.
•Check that the batteries are installed in the unit and that the battery power is not low.
•Do not pause for over 60 seconds while storing.
•Do not enter a phone number more than 22 digits long.
Useful
While programming or | • To answer the call, lift the handset. Start |
searching, the unit starts to | again from the beginning after hanging |
ring and stops the program/ | up. |
search. |
|
Information
For assistance, please call: | 35 |