Panasonic KX-TCD700AL Making Calls, To Edit/Clear Numbers in the Redial List, Direct Call

700al australian 2 5 02 2/5/02 3:00 pm Page 16

➡Making Calls

To Edit/Clear Numbers in the Redial List

To edit and clear numbers in the redial memory, press X, select number and then follow from step 2 (Page 22).

Direct Call

You can store one number into memory and then call this number by pressing O. Incoming calls are accepted. To use this feature, store the direct call number and turn on the mode by programming (see page 34). The factory pre-set is OFF.

Dialling the Stored Number

Make sure that “Ë” is displayed (see page 34), then Z O.

•The number stored in the direct call memory is dialled automatically.

•When the handset is in “direct call” mode, it is not possible to make any calls until direct call is cancelled. This also includes emergency calls.

To Select the Receiver Volume

3 levels (HIGH, MEDIUM, LOW) are available. The factory preset is MEDIUM.

1.During conversation, Z S, or U to select level

S = receiver volume up

U = receiver volume down

⁄⁄⁄ = HIGH, ⁄⁄ = MEDIUM, ⁄ = LOW

2.After volume selection, Z W

(The display returns to length of call, etc).

00-00-31

ÂÊ Á Ë È Í

ÎÏ  Ô Ó Ò

vol ⁄⁄⁄

ÂÊ Á Ë È Í

ÎÏ  Ô Ó Ò

S U

vol ⁄œœ

ÂÊ Á Ë È Í

ÎÏ  Ô Ó Ò

00-00-36

ÂÊ Á Ë È Í

ÎÏ  Ô Ó Ò

Dialling a Stored Hot Key Number

(To register a number as Hot Key, see page 19).

You can assign up to 9 phone numbers in the speed dial list as hot key dials. The dialling buttons (A to I) function as memory stations.

1.Z and hold a memory station number (A to I).

•The stored number is displayed.

•To search a number, Z U or S until the desired number is displayed.

2.Z O

•The number is dialled automatically.

3.To hang up, Z P.

16