Linksys PAP2-NA manual Using the Phone Adapter’s Interactive Voice Response Menu

Page 12

Phone Adapter with 2 Ports for Voice-over-IP

Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu

Overview

You may need to manually configure the Phone Adapter by entering the settings provided by your Internet phone service provider. Chapter 4 explains how to use the Interactive Voice Response Menu to configure the Phone Adapter’s network settings. You will use the phone’s keypad to enter your commands and select choices, and the Phone Adapter will respond with voice responses.

NOTE: If your Internet phone service provider sent you the Phone Adapter, then it may be pre- configured for you, and you do not need to change any settings. Refer to the instructions provided by your service provider for more information.

Accessing the Interactive Voice Response Menu

1.Use a telephone connected to the PHONE 1 or PHONE 2 port of the Phone Adapter.

2.Press **** (in other words, press the star key four times).

3.Wait until you hear “Configuration menu. Please enter option followed by the # (pound) key or hang up to exit.”

4.Refer to the following table that lists actions, commands, menu choices, and descriptions. After you select an option, press the # (pound) key. To exit the menu, hang up the telephone.

Using the Interactive Voice Response Menu

While entering a value, such as an IP address, you may exit without entering any changes. Press the * (star) key twice within half a second. Otherwise, the * will be treated as a decimal point or dot.

After entering a value, such as an IP address, press the # (pound) key to indicate you have finished your selection. To save the new setting, press 1. To review the new setting, press 2. To re-enter the new setting, press 3. To cancel your entry and return to the main menu, press * (star).

Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu

8

Overview

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Phone Adapter How to Use this Guide Copyright and TrademarksTable of Contents Back Panel Front PanelIntroduction WelcomeWhat’s in this Guide? Introduction What’s in this Guide? Getting to Know the Phone Adapter Back Panel PortsFront Panel LEDs Connecting the Phone Adapter Instructions for Connecting the Phone AdapterOverview Router Phone AdapterConnect the Ethernet Network Cable Placement Options Stand OptionWall-Mount Option Remove the plate from the Phone Adapter’s bottom panelUsing the Phone Adapter’s Interactive Voice Response Menu Accessing the Interactive Voice Response MenuUsing the Interactive Voice Response Menu Has been enabled or disabled. If Interactive Voice Response Menu121 Enter the network 7932 Enter 1 to enable This feature is protected by a Entering a Password Configuring the Settings for Your Internet Phone ServiceAppendix a Troubleshooting Common Problems and SolutionsApplication Start and End Protocol IP Address Enable Internet phone 5060 toIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 toIP address Phone Adapter Internet phone 69 to IP address Phone Adapter Internet phone 69 to Frequently Asked Questions Ethernet LED does not light upAppendix B Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Storage Temp Operating HumidityStorage Humidity 10~90% Non-CondensingAppendix E Warranty Information Limited WarrantyAppendix F Regulatory Information FCC StatementAppendix G Contact Information Linksys
Related manuals
Manual 33 pages 13.67 Kb
Top Page Image Contents