Uniden UH073sx manual Attaching the Battery Pack

Page 7

Attaching the Battery Pack

Contacts

1. Place the battery pack onto the back of the radio. It will only fit in one way.

2. Snap the battery release clip until it clicks. Be sure the battery pack fits tightly against the uh073sx body.

CAUTION!

Avoid exposing the Lithium Ion battery, attached or unattached to the radio, in direct sunshine, heated cars, or in areas with temperatures below –20°C (–4°F) or above +60°C (+140°F). Exposing the chemicals contained within the battery pack to temperatures above +60 °C (+140°F) may cause the battery to rupture, fail or reduce performance.

In case of exposure to cell contents, wash the affected area thoroughly, and seek medical attention.

Additional battery cautions should be applied as described on page i of your Owner s Manual.

Attaching the Beltclip

1. Hold the beltclip in the direction.

2. Apply it to the hanger piece on the back of the radio. Then slide it up.

3. You will hear a click. The beltclip is firmly attached.

5

Image 7
Contents Operating Guide Waterproof JIS7 Contents Introduction FeaturesIncluded in Your Package Optional AccessoriesMounting the Drop-in Charger Getting StartedAttaching the Battery Pack Do not transmit when the uh073sx is in the drop-in charger Charging the Battery PackBattery Level Display Dup while turning on the radio OperationSelecting Channel Roger BeepSquelch To Transmit and Receive Using a Repeater Channel Example CH40 becomes active ScanningGroup Scan GS Mode Choosing a Priority Channel DROP-OUT DelayPriority Channel Programming Scan ChannelsProgramming Ctcss Code Advanced FeaturesCtcss Scan Operation To De-activate VOX To activate VOXBack Lighting Power SaveKeypad Lock Monitor Busy Channel LOCK-OUT BCLTo use monitor UHF Channel & Frequencies Ctcss Codes & Frequencies Uniden UH073SX UHF CB Transceiver Radio WarrantyControls & Indicators LCD Display