Uniden BC780XLT manual Channel Lockout, Lockout in Manual Mode, Lockout in Scanning Mode

5.Press ▲ or ▼ to select one of the delay periods provided and then press E. DLY appears on the display unless no delay has been set.

6.For Search mode, select SEARCH EVENT - DELAY, then set the delay period.

Note: The delay periods are as follows:

•None: Delay feature off

•1 sec.: Delays for 1 sec. before re-scanning

•2 sec.: Delays for 2 sec. before re-scanning

•4 sec.: Delays for 4 sec. before re-scanning

•Infinite: Stays on until SCAN is pressed

•-2 sec.: Stays for 2 sec. only before re-scanning *

•-5 sec.: Stays for 5 sec. only before re-scanning *

•-10 sec.: Stays for 10 sec. only before re-scanning *

*Setting negative delay periods are useful if you are only interested in small segments of conversations. For example: If you set a -5 second delay, you will only hear 5 seconds of the conversation and then the scanner will resume scanning, whether or not the conversation is finished.

Channel Lockout

You can lockout any channel so it is not checked during normal scanning. You can restore the channel to scanning when you wish.

Lockout in Manual Mode

1. Press MAN.

2. Select a channel.

Enter the channel numbers. Press MAN again.

––– OR –––

Press MAN or HOLD/▲ to change higher, or LIMIT/▼ to lower the channel.

3. Press L/O to lockout the channel. L/O appears in the display.

Lockout in Scanning Mode

If the scanner keeps stopping on a particular channel due to noise or too frequent transmissions, you may want to keep that channel from scanning.

1.Wait until the scanner stops at the channel.

2.Then press L/O.

25