Charging Accessory Handsets
The handset is powered by a rechargeable battery pack. The battery recharges automatically when the handset is placed in the charger.
1.Connect the AC adapter to the DC IN 9V jack and to a 120V AC outlet that is not controlled by a wall switch.
Caution: Use only the Uniden
2.Set the charger on a desk or tabletop, and place the handset in the charger with the keypad facing forward.
3.Make sure that the charge LED illuminates. If the LED does not illuminate, check to see that the AC adapter is plugged in and the handset makes good contact with the base charging contacts.
4.Charge the handset battery pack for at least
Registering Accessory Handsets
If you purchase an accessory handset, you need to register the handset before use. Only one handset can be registered at a time. Handsets supplied with the phone are registered to the base by the factory. When charged, pre- registered handsets display a handset ID number. Handsets that have not been registered display MODELS VARY! CHARGE HANDSET ON THE BASE FOR REGISTRATION OR REFER TO OWNER’S MANUAL. (If an accessory handset has ever been registered to a base, you must reset the handset before you can register it to a new base. See Resetting Handsets on page 21.)
When you register an accessory handset to the base, the handset ID will be assigned.
Note: Before registering any accessory handsets, make sure the accessory handset's battery is fully charged.
20